Hotpoint RB526DHWW Manuel d'utilisation et d'entretien télécharger pdf (Page 25)

Care and cleaning of the range. GEAppliances.com

Oven Light Replacement (on some models)

SHOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect

the electrical power to the range at the main fuse or circuit breaker panel.

Failure to do so may result in electric shock or burn.

WARNING

BURN HAZARD: The glass cover and bulb should be removed when cool.

Touching hot glass with bare hands or a damp cloth can cause burns.

CAUTION

To remove the cover:

Hold a hand under the cover so it doesn’t

fall when released. With fingers of the

same hand, firmly push back the wire

cover holder. Lift off the cover.

Do not remove any screws to remove the

cover.

Replace bulb with a 40-watt household

appliance bulb.

To replace the cover:

Place it into groove of the light receptacle.

Pull wire forward to the center of the cover

until it snaps into place.

Connect electrical power to the range.

For models JBS27DI and JBS27RI: Replace

oven lamp with 240 volts lamp only.

Wire cover holder

The stainless steel handles (on some

models) can be cleaned with a commercially

available stainless steel cleaner. Cleaners

with oxalic acid such as Bar Keepers Friend

Soft Cleanser™ will remove rust, tarnish, and

small blemishes. Use only a liquid cleanser

free of grit and rub in the direction of the

brush lines with a damp soft sponge. Do not

use appliance wax or polish on the stainless

steel.

Do not wipe the handle with a soiled dish

cloth or wet towel. Do not use scouring

pads, powdered cleaners, bleach or cleaners

containing bleach because these products

can scratch and weaken the finish.

Stainless Steel Handles (on some models)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Hotpoint RB526DHWW Manuel d'utilisation et d'entretien Page 25