Hotpoint 61DC Manuel d'utilisateur télécharger pdf (Page 11)

Clock/Minute Minder Operation (61DC & ARC60)

Here you can set a time period of up to 10 hours, that will count down.

When it reaches zero, the timer will emit an audible tone.

For Example: If you set 20 minutes, the audible tone will occur 20

minutes later.

SETTING THE MINUTE MINDER

Step 1 Ensure the time of day is set correctly.

Step 2 Press and release the ‘+’ button.

Note: Step 3 must be started within 10 seconds, otherwise

you must repeat Step 2.

Step 3 Press the ‘+’ button to set the required time period.

A ‘Bell’ symbol will light up.

The time period can be adjusted, by using the ‘+’ button to

increase the time period or the ‘-’ button to decrease the

time period.

Release all buttons, the timer display will show the remaining time

period.The ‘Bell’ symbol will remain lit to signify that a time period has

been set.

At the end of the set time an audible tone will be heard and the ‘Bell’

symbol will flash.

Step 4 To cancel the audible tone press the ‘+’ button.

To cancel the minute minder period press the ‘-’ button until 0.00 is

displayed in the window then release the button.

If at any time the display shows flashing zero’s, it is likely that the

electricity supply has been interrupted.

Reset the timer to the correct time of day.

Note: The Timer display will show the minute minder

period as follows:

Any period up to 99 minutes and 50 seconds -

The display shows MINUTES and SECONDS (10s intervals)

eg. 19 minutes 50 seconds

Any period between 100 minutes (1 hour 40 minutes) and up

to 10 hours -

The display shows HOURS and MINUTES

eg. 1 hour 41 minutes

0.00

19.50

1.41

0.00

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Pas de commentaire

Hotpoint 61DC Manuel d'utilisateur Page 11