Hotpoint 61DC Manuel d'utilisateur télécharger pdf (Page 5)

Installation

WARNING –THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure

that the voltage corresponds with your

supply volt

age,

this is stated on the rating plate, which is situated

on the outer rear panel.

The model number and serial number are located on the front of the cooker, as shown on

the Feature’s page.

The cooker must be connected by a competent person such as one who is a, NICEIC registered

contractor to a suitable double-pole control unit with a minimum rating of 32A and a minimum

contact clearance of 3mm (applicable to newer properties, older properties where a 30A

double pole control unit and a minimum contact clearance of 3mm is acceptable).

The double pole control unit should be fitted adjacent to the cooker, in accordance with

IEE regulations. The control unit must be within 2 metres of but not directly above the

appliance and should be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm

, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains

cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable

should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel

and is not trapped to the rear wall when pushing the cooker into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm)

and level the cooker.

The feet can be simply screwed in or out to lower or raise the cooker.

After the correct height is achieved, lock the feet into position by tightening the locking nut

using an open ended spanner.

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.

NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space

either side need only be sufficient to allow withdrawal of the cooker for servicing. It can be

used with cabinets one side or both as well as in an angled corner setting. It can also be

used freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than

150mm and should be

protected by heat resistant material. Any overhanging

surface or

cooker hood should not be nearer than 650mm.

Note: This appliance must NOT be fitted on a platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of

the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television

interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor

covering is not damaged.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint 61DC Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Hotpoint 61DC