Hotpoint EG21 & EG22 Manuel d'utilisateur télécharger pdf (Page 26)

Unpack the components from inside the grill and oven: Check that

the following parts are present.

Grill pan and grid Grill pan handle

Baking dish Pan supports (2)

Oven shelves (2) Enamelled discs (4)

Literature Brass burner port rings (4)

Aluminium burner bodies (4)

The cooker must be fitted with a stability device firmly secured to the

fabric of the building. The M6 bolt at the top of the rear of the cooker

can be used to engage a stability chain. Keep the chain clear of

controls and pipes on the rear of the cooker.

The chain must be fitted to the wall behind the cooker.

The cooker is designed to match the depth of standard 600mm work-

tops. An adaptor backplate should, therefore, be fitted within the

shaded area shown to allow the cooker to be pushed fully to the wall.

If a forward facing backplate is used, it must be chased into the wall.

Connection to the cooker should be made with an approved

appliance flexible connection to BS 669. A length of 0.9 to 1.25m is

recommended. The length of hose chosen should be such that when

the cooker is in situ, the hose does not touch the floor.

The temperature rise of areas at the rear of the cooker that are likely

to come in contact with the flexible hose do not exceed 70

530

300

200

Installation

Unpacking the

Cooker

Stability Chain

Connecting To

The Gas Supply

300

250

530

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Hotpoint EG21 & EG22 Manuel d'utilisateur Page 26