Hotpoint EG21 & EG22 Manuel d'utilisateur télécharger pdf (Page 27)

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Your cooker should have been checked to ensure

that

the voltage corresponds with your supply volt

age,

this is

stated on the rating plate, which is situated

on the front

of the plinth. The cooker must be connected by a com-

petent person eg. (NICEIC registered contractor) to

suitable double-pole control unit with a minimum rating

of 32A and a minimum contact clearance of 3mm,

which should be fitted adjacent to the cooker, in accor-

dance with latest IEE regulations.

The power supply cable should conform to B.S.6004

with a conductor size of 2.5mm

minimum.

The control unit should be easily accessible in the

event of an emergency, but must be within 2 metres

of and not directly above an appliance.

This appliance conforms to EN 55014 regarding

suppression of radio and television interference.

Access to the mains terminals is gained by removing

the rear access cover.

The mains cable must pass through the cable clamp

adjacent to the terminal block. Sufficient cable should

be used to allow the cooker to be pulled out for

servicing.

Ensure that the mains cable is routed away from any

brackets affixed to the rear panel and is not trapped to

the rear wall when pushing the cooker into

position between cabinets.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Hotpoint EG21 & EG22 Manuel d'utilisateur Page 27