Hotpoint X153E Manuel d'utilisateur télécharger pdf (Page 5)

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Your cooker should have been checked to ensure

that the

voltage corresponds with your supply volt

age,

this is stated

on the rating plate, which is situated

on the rear panel.

The cooker must be connected by a competent person,

such as one who is a NICEIC registered contractor, to a suit-

able double-pole control unit with a minimum rating of

32A and a minimum contact clearance of 3mm (applicable

to newer properties, older properties where a 30A double

pole control unit and a minimum contact clearance of

3mm is acceptable).

The double pole control unit should be fitted adjacent to

the cooker, in accordance with IEE regulations. The control

unit must be within 2 metres of, but not directly above the

appliance and should be easily accessible in the event of

an emergency.

The power supply cable should conform to B.S.6004 with a

conductor size of 6mm

minimum.

This appliance conforms to EN 55014 regarding

suppression of radio and television interference.

Access to the mains terminals is gained by removing the

rear access cover.

The mains cable must pass through the cable clamp

adjacent to the terminal block. Sufficient cable should be

used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any

brackets affixed to the rear panel and is not trapped to the

rear wall when pushing the cooker into position between

cabinets.

The height of the cooker can be adjusted by means of

adjustable feet in the plinth (900mm - 915mm). Adjust the

feet by tilting the cooker from the side. Then install the

product into position.

NOTE: This appliance must not be fitted on a platform.

The cooker is designed to fit between kitchen cabinets

spaced 500mm apart. The space either side need only be

sufficient to allow withdrawal of the cooker for servicing. It

can be used with cabinets one side or both as well as in a

corner setting. It can also be used free-standing.

Adjacent side walls which project above hob level, must

not be nearer to the cooker than 150mm and should be

protected by heat resistant material. Any overhanging

surface or cooker hood should not be nearer 650mm.

Siting the Cooker

150 mm

650 mm

1 2 3 4 5 6 7 8 9 10 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Hotpoint X153E Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles Hotpoint X153E