Hotpoint WK 30I AX0 UK Mode d'emploi télécharger pdf (Page 5)

while the indicator will go out.

The water owing out from spout is very hot,

handle carefully and never touch it with hand

to avoid scalding.

6. If you want to boil water again, only press down

the Power switch again to restart the kettle.

7. The kettle may be stored on the power base

when not in use. Always disconnect the power

supply when not use.

BOIL-DRY PROTECTION

Should you accidentally let the kettle operate without

water, the boil-dry protection will automatically switch

off the power. If this occurs, allow the kettle to cool

down before lling with cold water.

CLEANING AND

MAINTENANCE

Always disconnect the appliance from the power

outlet before cleaning.

1. Never immerse the kettle, power cord or power

base in water and never allow moisture to get in

contact with these parts.

2. Wipe the outside of the body with a damp cloth

or cleaner. Never use a hazardous cleaner.

Do not use chemical, steel, wooden or abra-

sive cleaners or brushes to clean the outside

of the kettle to prevent any gloss loss.

EMPTYING YOUR KETTLE

1. After your kettle has completely cooled down,

unplug it from the mains supply socket.

2. Press the Lid release button and hold your kettle

sideways over a sink. Then, tip your kettle upsi-

de down.

3. Still holding your kettle over the sink, turn it the

right side up and allow any water to drain out of

the spout.

4. Repeat step 2 and 3 until the water has been

emptied from your kettle.

5. If your kettle will not be used for an extended

period (e.g. if you are on holiday), it’s recom-

mended that emptying it rstly. Before using your

kettle again, carry out several boil cycles and di-

scard the water each time.

REMOVAL OF MINERAL

DEPOSITS

To maintain its performance, your kettle will require

descaling every three months or so. If you live in a

hard water area, the kettle may need to be descaled

more frequently.

1. Fill your kettle to the MAX level and place an

empty cup on the drip tray. Press down the Po-

wer switch and wait for the water to be dispen-

sed into the cup.

2. Add a citric acid-based proprietary descaling

product to the hot water in the cup and stir.

3. Tip the contents of the cup into the water tank

and close the lid.

4. Place the empty cup on the drip tray and press

down the Power switch.

5. Wait for the water to be dispensed into the cup.

6. Discard the water from the cup.

7. Repeat steps 4, 5 and 6 until the water level is

at the MIN mark. Open the lid and empty any

remaining water into the sink. Rinse your kettle

by lling it with clean water and emptying it into

the sink.

8. Fill your kettle with fresh water to the MAX level

and place an empty cup on the removable shelf.

9. Press down the Power switch and wait for the

water to be dispensed into the cup.

10. Discard the water in the cup.

11. Repeat steps 8 and 9 until the water level is at

the MIN mark. Open the lid and empty any re-

maining water into the sink.

GUARANTEE

12 months Parts and Labour Guarantee

This certicate of guarantee represents the guarantee (“Guarantee” he-

reinafter) offered by Indesit Company UK Limited with registered ofce

at Peterborough PE2 9JB in relation to products purchased in the United

Kingdom and Indesit Ireland Limited with registered ofce in Dublin 9,

Ireland for products purchased in the Republic of Ireland. This Guaran-

tee does not affect your statutory rights.

Your product has the benet of our manufacturer’s Guarantee, which

covers the product for twelve months from the date of purchase.

This gives you the reassurance that if, within that time, your product

is proven to be defective because of either workmanship or materials,

we will, at our discretion, either repair or replace the product at no cost

to you.

This Guarantee is subject to the following conditions:

• Documentary proof of original purchase date is provided.

• Cosmetic damage must be reported within 14 days from the date

of purchase.

• The product has been installed and operated correctly and in ac-

cordance with our operating and maintenance instructions.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WK 30I AX0 UK Mode d'emploi Page 5

Commentaires sur ces manuels