Hotpoint DDP-700 Manuel d'utilisateur télécharger pdf (Page 48)

MODEL NAME

DDP-700

USER GUIDE

PAGE

ADVANCE FEATURES

FACTORY PRESET -Routable Code:

This is the routable code number and is preset in the factory. When LCR is “on”, your DDP-700 will compare the

dialed number to the routable code table, if it match, it will route the call.

1. Press up to select LCR menu.

2.Press . Your DDP-700 will ask you to enter the PIN Code. (See PIN CODE Setting)

3. Enter the PIN Code. Press .

4. Press to select ROUTABLE.

4.1 Press to select NEW

4.1.1 Press .

4.1.2 Enter area code, maximum 5 different area codes each maximum of 6 digits.

4.1.3 Press .

4.1.4 Press and Hold to exit LCR programming and return to standby mode, press once

to exit routable code setting or repeat 4.1 to store another code.

4.2 Press to select EDIT

4.2.1 Press .

4.2.2 Search the routable code to be edit using . Press .

4.2.3 Press to delete one character to the left side of the cursor or add character by

pressing the correct number.

4.2.4 Press . A confirmation tone is heard.

4.2.5 Press and Hold to exit LCR programming and return to standby mode, press once

to exit edit routable code or repeat 4.2.

It is highly recommended that you just leave this codes untouched. However, if you add routable codes you can

program them. Factory preset area codes are : 0, 00, 3 and 4.

Routable Code

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 57 58

Pas de commentaire

Hotpoint DDP-700 Manuel d'utilisateur Page 48