Hotpoint IDC 85 S (GCC) Mode d'emploi Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
11
EN
Sorting laundry
• Check the symbols on the care labels of the various
garments to verify whether the garments can be safely
tumble dried.
• Sort laundry according to the type of fabric.
• Empty all pockets and check for loose buttons.
• Close zips and hooks and fasten belts and strings without
tightening them.
Wring out garments to remove the maximum amount of
water possible.
!
Do not load the dryer when garments are dripping wet.
Maximum load sizes
Do not overload the drum.
The following values indicate the weight of dry garments:
Natural fibres: maximum kg
Synthetic fibres: maximum kg
! Do not overload the dryer as this may result is reduced
drying performance.
Care labels
Always check the care labels, especially when placing
garments in the tumble dryer for the first time. Below are
the most commonly used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
Drying times
Drying times are approximate and may vary depending on
the following:
• Amount of water retained by items after the spin cycle:
towels and delicate items retain a lot of water.
• Fabrics: items of the same fabric, but with different textu-
re and thickness may have different drying times.
• Amount of laundry: single items and small loads may
take longer to dry.
• Drying: if items are to be ironed, they can be removed
from the dryer while still slightly damp. Items that require
complete drying can be left longer.
• Heat setting.
Temperature of the room: the lower the temperature
of the room, the longer it will take for the dryer to dry
clothing.
• Bulk: certain bulky items require special care during the
drying process. We suggest removing these items and
replacing them in the dryer once they have been sha-
ken out: repeat this procedure several times during the
course of the drying cycle.
! Do not over-dry items.
All fabrics contain natural dampness which helps to keep
them soft and fluffy.
The drying times provided refer to the automatic Cupboard
dry programmes.
The Timed drying settings are also indicated to enable you
to select the most suitable timed option.
Laundry
8
3
Troubleshooting
Possible causes / Solutions:
The plug has not been inserted far enough into the socket to make contact.
There has been a power cut.
The fuse has blown. Try connecting another appliance to the same socket.
If an extension cord is used, try connecting the dryer plug directly into the socket.
The door has not been closed properly.
The programme has not been set correctly (see How to carry out a drying cycle).
The START button has not been pressed (see How to carry out a drying cycle).
The filter has not been cleaned (see Care and maintenance).
The water container must be emptied? The “Empty water container” indicator light is
on (see Care and maintenance).
The condenser needs to be cleaned (see Care and maintenance).
An incorrect drying time was selected for the type of load (see Laundry).
The air intake grille is blocked (see “Installation” and “Care and Maintenance”).
The items are too wet (see Laundry).
The dryer is overloaded (see Laundry).
• This is normal, especially if the dryer has not been used for a long time. If the noise
persists during the entire cycle, contact the Technical Assistance Centre.
If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical
Assistance Centre (see Assistance).
Problem:
The dryer does not start.
Drying times are too long.
The dryer is noisy during the rst few
minutes of operation.
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire