Hotpoint IDC 85 S (GCC) Mode d'emploi Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
EN
Where to install the tumble dryer
If the dryer is installed below a worktop,
ensure there are 10 mm
between the upper panel
of the dryer and any
objects above it, and 15
mm between the sides of
the machine and the walls
or furniture units adjacent
to it. This ensures
adequate air circulation.
The appliance must be
installed with the rear surface placed against a
wall.
Ventilation
Make sure that the dryer is installed in a room free of humidity
and with adequate air circulation. The flow of air around the
dryer is essential to allow water to condense during drying;
the dryer will not function properly if it is placed in an enclosed
space or inside a cabinet.
Some condensation may form if the dryer is used in a small or
cold room.
Water drain
If your dryer is installed next to a drain the water can be
plumbed into this drain. This does away with the need to
empty the water container. If the dryer is stacked onto or
installed next to a washing machine it can share the same
drain. The height of the drain must be less than 3’ (1 m) from
the bottom of the dryer.
Remove existing hose from position shown in picture A and fit a
suitable length of hose and connect as shown in picture B.
The drain tube has to be below 1 m from the bottom of
the Dryer
Make sure that the hose is not squashed or kinked
when the dryer is in its  nal location.
1
2
2
1
Less than 1m
Picture A Picture B
We do not recommend that the dryer is
installed in a cupboard but the dryer must never
be installed behind a lockable door, a sliding door
or a door with a hinge on the opposite side to
that of the dryer door.
Electrical connections
Before plugging the appliance into the socket,
10 mm
15 mm
15 mm
check the following:
Make sure your hands are dry.
The socket must have an earth connection.
The socket must be able to withstand the
machine’s maximum power output as
indicated on the rating plate.
The power supply voltage must fall within the
values indicated on the data plate.
Do not use extension leads. Do not pull the
power supply cable. Do not use multiple plug
adaptors if the appliance is fitted with a plug.
For appliances with fitted plug, if the plug is
not suitable for you socket outlet, contact a
qualified technician.
The dryer must not be installed outdoors, even
if the space is sheltered.
Once installed, the dryers electrical wire and
plug must be within reach.
The power cord must not be bent or
squashed.
If the plug being replaced is a non-rewirable
type, then the cut-off plug must be disposed of
safely. DO NOT leave it where it can be inserted
into a socket and create a shock hazard.
The power must be regularly checked. If the
supply cord is damaged, it must be replaced
by service agent . (see Assistance).
The manufacturer denies any
responsibility should any of these rules
not be followed.
If in doubt about any of the above
consult a quali ed electrician.
Preliminary information
Once the tumble dryer is installed, clean the inside of the drum
before operating it and remove any dirt accumulated during
transportation.
Installation
Vue de la page 1
1 2 3 4 5 6 7 ... 11 12

Commentaires sur ces manuels

Pas de commentaire