Hotpoint BCB 8020 AA F C O3(RU) Guide de l'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
* Available only on certain models
"FOOD CARE ZONE"*
“Food Care Zone” drawer is specically designed to maintain a low
temperature to preserve fresh food for longer time (for example , fresh
pasta, sour cream, pesto/salsa,homemade preparation,pastry cream,
pudding,cream cheese , cold cuts, desserts, meat and sh).
The internal temperature of the drawer is between +3 °C and -2 °C.
For the correct functioning of the “Food Care Zone” drawer, it is
necessary that:
the appliance is turned on
one of the following special functions is not selected: Standby,
Cooling-O, Vacation (in this case, remove the food contained in
it).
HOW TO STORE FOOD AND BEVERAGE
Legend
TEMPERATURE ZONE
Suggested for the storage of tropical fruit, cans, drinks,
eggs, sauces, pickles, butter, jam
COOL ZONE
Suggested for the storage of cheese, milk, daily food,
delicatessen, yogurt
COOLEST AREA
Suggested for storage of cold cuts, desserts, meat and
sh
FRUIT & VEGETABLE DRAWER
FREEZER DRAWERS
FREEZING ZONE DRAWER
(Max cool zone)
Suggested to freeze fresh/cooked food
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The control panel is
switched o, the appliance
does not work.
The appliance could be in On/Standby
mode.
There may be an appliance power
supply problem.
Activate the appliance with the On/Standby button
Make sure:
there is not a power outage
the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i.e. allows
the appliance to be powered)
the household electrical system protection devices are ecient
the power cable is not broken.
The inside light does not
work.
The light may need replacing. Models with lamp: disconnect the appliance from the power supply,
check the lamp and, if necessary, replace it with a new one (see the
section “Lamp or LED replacement).
The appliance could be in On/Standby
mode.
Models with LED lights: contact the authorised Service Centre.
Activate the appliance with the On/Standby button
The temperature inside the
compartments is not low
enough.
There could be various causes (see
“Cures”).
Make sure:
the doors close properly
the appliance is not installed near a heat source
the set temperature is adequate
the circulation of air through the vents at the bottom of the
appliance is not obstructed.
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrost water drain hole (see the section “Appliance
Maintenance and Cleaning”)
The front edge of the
appliance, at the door striker
seal, is hot.
This is not a defect. It prevents
condensation from forming.
No cure is necessary.
Vue de la page 1
1 2 3 4

Commentaires sur ces manuels

Pas de commentaire