What to do if... Possible reasons Solutions
The red light
ashes and
an acoustic signal sounds
Door open alarm
It is activated when a door remains open
for a long period of time.
Close the doors of the product to deactivate the acoustic signal. If
the acoustic signal does not go o, it is a power failure alarm (see the
section Power failure alarm).
The red light
ashes and
an acoustic signal sounds
and remains on even with
the door closed.
Power failure alarm
It is activated in case of a prolonged
power outage causing an increase in the
freezer compartment temperature.
Note: A dierent product temperature
cannot be set until the power failure alarm
is deactivated.
Before deactivating the acoustic signal, it is advisable to pay attention
to the temperature shown on the temperature display, corresponding
to the highest temperature reached in the freezer compartment
during the power failure. Press the “Stop Alarm” button briey
to deactivate the acoustic signal. After pressing the button, the
temperature display shows the set temperatures again. If the freezer
compartment has not yet reached the optimum food preservation
temperature, the freezer compartment temperature alarm could be
activated (see freezer compartment temperature alarm). Check the
food before consuming it.
The red light
comes
on (without ashing), an
acoustic signal sounds and
the freezer compartment
temperature display ashes.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
temperature is not optimum. This may
happen: with rst use, after defrosting
and/or cleaning, if large amounts of
food are placed inside the freezer or
when the freezer door has not been
closed properly.
Press the “Stop Alarm” button briey to deactivate the acoustic signal.
The red light goes o automatically when optimum temperature
conditions are reached. If the freezer compartment temperature alarm
stays on, contact the Authorised Service Centre.
The red light
comes on,
an acoustic signal sounds
and the letter “F” ashes on
the display.
Malfunction alarm
The alarm indicates a fault in a technical
component.
Call the authorised Service Centre. Press the “Stop Alarm” button
briey to deactivate the acoustic signal.
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
• Visiting our website docs . hotpoint . eu
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
* Available only on certain models
Commentaires sur ces manuels