Hotpoint SL B18 AA0 UK Mode d'emploi télécharger pdf (Page 13)

1313

• Cleantheltersand,ifneeded,replacethem.

• Make sure the expansion pipe, exible hose and brush are not

blocked.

• Changethedustbag.Iflargequantitiesofverynedust/powderare

sucked up (e.g. our, etc), the Pure Clean dust bag may become

clogged.

• Cleanthedustcontaineranditslters.

• Battery not charged.

• The batteries were positioned incorrectly inside the battery

compartment. Position the two AAA batteries making sure of the

positive and negative poles.

• Remove batteries; then position them again, making sure of the

positive and negative poles.

• Electronic appliances or obstacles may be interfering or shielding

with the infrared signal.

• Ifverynedustorpowdersaresuckedupsuchasour,etc.small

electrostatic discharges could occur. When sucking up materials

previously mentioned, we advise not to use the metal extension pipe,

butonlytheplasticexiblehoseandtosetalowsuctionpowerlevel.

• One or more attachments were assembled incorrectly. Make sure the

ltersandbrusheswereassembledaccordingtotheseinstructions.

In the model with dust bag make sure that the gasket is correctly in

place too.

• The dust bag/container is full. Replace the dust bag or clean the dust

container.

• Cleantheltersand,ifneeded,replacethem.

• The air regulator is open. Make sure it was closed correctly.

• Reduce suction power, especially on carpets and fabrics in general.

Open the air regulator to reduce the “suction effect”.

• The Pure Clean dust bag or dust container was assembled incorrectly.

Make sure it is correctly in place so that the safety lever will let you

close the dust compartment lid.

Low suction power.

Remote Power not working.

Small electrostatic

discharges occur while

sucking up.

The vacuum cleaner whistles

or vibrates when in use.

The brush moves with

difculty.

The dust compartment lid

cannot be closed.

• The plug was not inserted or is not making contact.

• Changethedustbag.Iflargequantitiesofverynedust/powderare

sucked up (e.g. our, etc), the full dust bag indicator may light up

although the bag is not full yet. The reason is that the Pure Clean

dust bag is able to retain very ne dust/powder particles, thus

ensuring maximum hygiene.

• Clean the dust container in models without dust bag.

• Cleantheltersand,ifneeded,replacethem.

• Make sure the expansion pipe, exible hose and brush are not

blocked.

The vacuum cleaner cannot

be switched on.

The full dust bag/container

indicator lights up although

it is not full yet.

TROUBLESHOOTING

Problem Possible causes / Solutions

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SL B18 AA0 UK Mode d'emploi Page 13

Commentaires sur ces manuels