Hotpoint SL M07 A3E O Mode d'emploi télécharger pdf (Page 13)

1313

hotpoint.co.uk

TROUBLESHOOTING

Problem Possible causes / Solutions

The vacuum cleaner cannot be

switched on.

• Check if the Start/Stop button was pressed.

• The plug was not inserted or is not making contact.

• If the product is in park position with the Start&Pause function

(if available) remove the brush from housing and press the

Start/Stop button.

The full dust container indicator

lights up although it is not full yet.

• Clean the dust container.

• Clean the lters and, if needed, replace them.

• Make sure the expansion pipe, exible hose and brush are

not blocked.

Low suction power. • Clean the lters and, if needed, replace them.

• Make sure the expansion pipe, exible hose and brush are

not blocked.

• Clean the dustbin and its lters.

• Check if the level of the dust is on the max level, in case empty

the dustbin.

Remote Power not working. • Battery not charged.

• The batteries were positioned incorrectly inside the battery

compartment. Position the two AAA batteries making sure of

the positive and negative poles.

• Remove batteries; then position them again, making sure of

the positive and negative poles.

• Electronic appliances or obstacles may be interfering.

• Overheating of the motor. Heavy use can lead to the

overheating of the motor. So wait for 60-90 minutes while

the motor cools down (It depends from physical external

parameters).

Small electrostatic discharges occur

while sucking up.

• If very ne dust or powders are sucked up such as our, etc.

small electrostatic discharges could occur. When sucking

up materials previously mentioned, we advise not to use the

metal extension pipe, but only the plastic exible hose and to

set a low suction power level.

The vacuum cleaner whistles or

vibrates when in use.

• One or more attachments were assembled incorrectly. Make

sure the lters and brushes were assembled according to

these instructions.

• Clean the lters and, if needed, replace them.

• The air regulator is open. Make sure it was closed correctly.

The brush moves with difculty. • Reduce suction power, especially on carpets and fabrics in

general. Open the air regulator to reduce the “suction effect”.

The vacuum cleaner switch off while

using

• Overheating of the motor. Heavy use can lead to the

overheating of the motor. So wait for 60-90 minutes while

the motor cools down (It depends from physical external

parameters).

• Make sure the expansion pipe, exible hose and brush are

not blocked.

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint SL M07 A3E O Mode d'emploi Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Aspirateurs Hotpoint SL M07 A3E O