Hotpoint ITWD 61252 G (PL) Mode d'emploi télécharger pdf (Page 9)

EN 7

CARE AND MAINTENANCE

Always unplug the washing machine before doing any maintenance.

Detergent dispenser

Clean the detergent dispenser regularly, at least

three or four times a year, to prevent detergent

build-up:

Detergent dispenser - picture 17a

1. Push in the buttons on each side of the dispenser

(picture 18).

2. Pull the dispenser towards you and remove

it. A small quantity of water can remain in the

dispenser. It is advisable to carry the dispenser in

an upright position.

3. Wash the dispenser using running water. You can

also remove the siphon caps in the dispenser for

cleaning.

4. Replace the siphon caps in the dispenser (if

removed). Make sure that they lock in place

5. Replace the dispenser by locating the bottom tabs

in the lid holes and pivot until both of the upper

buttons lock.

Detergent dispenser - picture 17b

1. Press the button to release the detergent dispenser

and remove it (picture 19). A small quantity of

water can remain in the dispenser, thus you should

carry it in an upright position.

2. Wash the dispenser using running water. You can

also remove the siphon cap on the back of the

dispenser for cleaning (picture 20).

3. Replace the siphon cap in the dispenser (if

removed)

4. Reinstall the dispenser by locating the dispenser’s

bottom tabs into the appropriate openings on the

lid, and by pushing the dispenser against the lid

until it locks into place.

Make sure that the detergent dispenser is

correctly reinstalled.

Water inlet hose ﬁlter

Check and clean regularly (at least two or three

times a year).

1. Unplug the washing machine.

2. Turn off the tap.

3. Unscrew the hose from the tap.

4. Carefully clean the ﬁlter located at the end of hose,

without disassembling it, for example with a tooth-

brush.

Note: Do not submerge the hose in water.

5. Screw the ﬂexible hose back onto the tap by hand.

Do not use pliers (risk of squashing the joint).

6. Turn on the tap and check that the connections

are water-tight.

7. Plug the washing machine back in.

Water inlet hose

(picture 21, 22 or 23, depending on model)

Check the inlet hose regularly for brittleness and

cracks and replace it if necessary using a new hose of

the same type.

The inlet hose as shown on picture 21 has a safety

valve to prevent the appliance against uncontrolled

water inlet; if the safety valve inspection window (A) is

red, the safety valve has been activated and the hose

must be exchanged. Contact out After-Sales Service

or your specialist dealer to obtain a new inlet hose.

For unscrewing the inlet hose as shown on picture 21,

you must push down the release lever (B) (if available)

while unscrewing it.

If your inlet hose has a transparent hose coating

(picture 22), periodically check the colour of the

transparent coating. If the transparent hose shows a

local dark colour change, this is an indication that the

hose may have a leak and should be replaced.

Contact our After-Sales Service team or specialist

dealer to obtain a replacement hose.

Appliance exterior and control panel

• Clean with a soft damp cloth.

• If necessary, use some soapy water or a mild

neutral detergent (do not use detergents containing

solvents, abrasive detergents, window or general-

purpose cleaners - they may harm the surfaces).

Appliance interior

• After each washing, leave the lid open for some-

time to allow the inside of the appliance to dry.

• If you never or seldom wash your laundry at

95°C, we recommend to occasionally run a 95°C

programme without laundry, adding a small amount

of detergent, to keep the interior of the appliance

clean.

Lid seal

• Check the condition of the lid seal periodically and

clean it from time to time with a damp cloth.

Water inlet hose(s)

• Check the hose regularly for brittleness and cracks.

Replace if necessary.

Filter

• Check and clean the ﬁlter regularly, at least 3 or

4 times a year (see “Cleaning the Filter/ Draining

Residual Water”).

Do not use ﬂammable ﬂuids for cleaning the ap-

pliance.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Hotpoint ITWD 61252 G (PL) Mode d'emploi Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Hotpoint ITWD 61252 G (PL)