Hotpoint 61DGW Mode d'emploi télécharger pdf (Page 17)

Installation

SPACE FOR FIXING

The cooker can be close fitted below hotplate level.

This requires a minimum distance of 600mm

between cupboard units of hotplate height.

When installing next to a tall cupboard, partition or

wall, for a minimum distance of 400mm above

hotplate level, allow a side clearance of at least

65mm. The diagram below illustrates the minimum

clearance between the cooker and adjacent walls,

cupboards etc.

The wall behind the cooker, 50mm below and

450mm above, and the width of the cooker, must be

a non-combustible material such as ceramic wall

tiles.

If the cooker is to be fitted close to a corner on the

left hand side, ensure that there is a clearance of at

least 50mm to allow the main oven door to open fully

for when removing oven shelves.

65 mm Min

840 mm Min

400 mm Min

600 mm Min

750mm Min

COOKER HOODS

If a cooker hood is to be installed, refer to the

cooker hood manufacturers' instructions regarding

fixing height.

UNPACKING THE COOKER

Unpack the components from inside the grill and

oven.

Check that the following parts are present:

Grill pan and grid Top oven/grill shelf heat shield

Pan supports Main oven shelves (2)

Enamelled burner caps (4) Top oven/grill shelf (1)

Aluminium burner bodies(4) Literature

LOCATION

The cooker may be located in a kitchen, kitchen/

diner or a bed-sitting room, but not in a room

containing a bath or shower. The cooker must not be

installed in a bed-sitting room of less than 20m

When adjusted for use on Butane (G30) or Propane

(G31), the cooker must not be installed in a room or

internal space below ground level, e.g. in a

basement.

PROVISION FOR VENTILATION

The room containing the cooker should have an air

supply in accordance with BS 5440: Part 2.

The room must have an opening window or

equivalent; some rooms may also require a

permanent vent. If the room has a volume between 5

and 10m

, it will require an air vent of 50cm

effective area unless it has a door which opens

directly to outside. If the room has a volume of less

than 5m

, it will require an air vent of 100cm

effective area. If there are other fuel burning

appliances in the same room, BS 5440: Part 2

should be consulted to determine air vent

requirements.

TECHNICAL DATA

Gas connection Rp ½ (½" BSP female)

Pressure test point Front left hotplate injector

Gas rate adjustment None

Aeration adjustment None

Electrical connection Flexible cord fitted with a

3 pin 13 amp plug

230/240V a.c. 50Hz.

13A fuse.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint 61DGW Mode d'emploi Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Barbecues et grillades Hotpoint 61DGW