Hotpoint LI2SNA Manuel d'utilisateur télécharger pdf (Page 4)

– operation 1) and mark 2 holes with a pencil, drill the

holes (Ø8mm), insert 2 wall plugs.

12. Fix the chimney support bracket to the wall using

two 5x45mm screws.

13. Hook the hood onto the bottom bracket.

14. Fix the hood into its final position on the wall

(ABSOLUTELY ESSENTIAL).

15. Connect a pipe (pipe and pipe clamps not

provided, to be purchased separately) for discharge of

fumes to the connection ring located over the suction

motor unit.

If the hood is to be used in ducting version, the other

end of the pipe must be connected to a device

expelling the fumes to the outside. If the hood is to be

used in filter version, then fix the deflector F to the

chimney support bracket G and connect the other

extremity of the pipe to the connection ring placed on

the deflector F.

16. Make the electrical connections.

17. Apply the chimney stacks and fasten them at the

top to the chimney support „G“ (17b) using 2 screws

(17a).

18. Slide the bottom section of the chimney down until

it completely covers the suction unit and slots into the

housing provided on top of the hood.

Replace the grease filter/s (and where foreseen the

grease collecting panels) and check that the hood is

operating correctly.

17b

4-13

17a

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Hotpoint LI2SNA Manuel d'utilisateur Page 4