Hotpoint EW41 Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
Installation
WARNING – THIS APPLIANCE MUST BE EARTHED.
Your cooker should have been checked to ensure
that
the voltage corresponds with your supply volt
age,
this is
stated on the rating plate, which is situated
on the front
of the plinth. The cooker must be connected by a
competent person eg. (NICEIC registered contractor) to
suitable double-pole control unit with a minimum rating
of 30A and a minimum contact clearance of 3mm,
which should be fitted adjacent to the cooker, in
accordance with IEE regulations.
The power supply cable should conform to B.S.6004
with a conductor size of 6mm
2
minimum.
The control unit should be easily accessible in the
event of an emergency, but must be within 2 metres
of and not directly above an appliance.
This appliance conforms to EN 55014 regarding
suppression of radio and television interference.
Access to the mains terminals is gained by removing
the rear access cover.
The mains cable must pass through the cable clamp
adjacent to the terminal block. Sufficient cable should
be used to allow the cooker to be pulled out for
servicing.
Ensure that the mains cable is routed away from any
brackets affixed to the rear panel and is not trapped to
the rear wall when pushing the cooker into
position between cabinets.
The cooker is designed to fit between kitchen
cabinets spaced 500mm apart. The space either side
need only be sufficient to allow withdrawal of the
cooker for servicing. It can be used with cabinets one
side or both as well as in a corner setting. It can also
be used free-standing.
This cooker is a class X appliance, as such adjacent
side walls which project above hob level, must not be
nearer to the cooker than 150mm and should be
protected by heat resistant material. Any overhanging
surface or cooker hood should not be nearer 650mm.
The height of the cooker can be adjusted by means of
adjustable feet in the plinth (900mm - 915mm). Adjust
the feet by tilting the cooker from the side. Then install
the product into position.
4
Siting the Cooker
150 mm
150 mm
650 mm
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 31 32

Commentaires sur ces manuels

Pas de commentaire