Hotpoint LTF 11M121 OL EU Mode d'emploi télécharger pdf (Page 18)

Technical data

Dimensions

width 59.5 cm

height 82 cm

depth 57 cm

Capacity 14 standard place-settings

Water supply

pressure

0,05 ÷ 1MPa (0.5 ÷ 10 bar)

7,25 – 145 psi

Power supply voltage See appliance data plate

Total absorbed power See appliance data plate

Fuse See appliance data plate

This dishwasher conforms to the

following European Community

Directives:

-2006/95/EC (Low Voltage)

-2004/108/EC (Electromagnetic

Compatibility)

-2009/125/EC (Comm. Reg.

1016/2010) (Ecodesign)

-97/17/EC (Labelling)

-2012/19/EC (WEEE)

The machine has a buzzer/set of tones

(dependingonthe

dishwasher model

) to inform the user that a command has

been implemented: power on, cycle end etc.

The symbols/indicator lights/LEDs on the control panel/

display may vary in colour and may have a flashing or fixed

light

(dependingonthedishwashermodel)

The display provides useful information concerning the type

of wash cycle, drying/wash-cycle phase, remaining time,

temperature etc etc.

* Only available in selected models.

Advice regarding the first wash cycle

After the installation, remove the stoppers from the racks and

the retaining elastic elements from the upper rack

(ifany).

Water softener settings

Before starting the first wash cycle, set the hardness lev-

el of

the water from the mains supply.

(seechapterRinse

aid and refined salt).

First load the softener tank with water, then introduce about

1 kg of salt. It is perfectly normal for water to flow out.

As soon as this procedure is complete, run a wash cycle.

Only use salt that has been specifically designed for dish-

washers.

After the salt has been poured into the machine, the LOW

SALTindicatorlight* switches off.

If the salt container is not filled, the water softener and

the heating element may be damaged as a result.

START 2END LIGHT

Somedishwashermodelsareequippedwithagreen

indicator light in the gap between the door and kitchen

top providing information on the phase of the current

wash cycle. One of the following operating modes can be

selected:

a) Disabled function

b) When the cycle starts the light goes on for few seconds,

stays off during the cycle and flashes at the end of the cycle

(defaultmode)

c) The light stays on during the cycle and flashes at the end

of the cycle. If the delayed start was set, the light goes on

either for the first few seconds or the entire duration of the

countdown, based on whether mode b) or c) was set.

The light goes off every time the door is opened.

To select the mode you prefer, switch on the machine, hold

down button P until one of the three letters appears on the

display, press button P

untilyoureachthedesiredletter(or

mode), hold down button P to confirm the selection.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint LTF 11M121 OL EU Mode d'emploi Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle Hotpoint LTF 11M121 OL EU