Hotpoint HTV10 Manuel d'utilisateur télécharger pdf (Page 6)

Installing your Cooker Hood

6

Top Extraction (Fig.4)

If the exhaust air is being drawn upwards,a

pipe with a diameter of 100mm is necessary

and the blanking plate must be fitted in the

rear outlet. To check that the hood is set up

for extraction, open the grille panel and make

sure that the conversion lever on the unit is in

the exhausting position.

Rear Extraction (Fig.5)

If the air is to be drawn off to the rear, a pipe

with a diameter of 100mm is necessary and

the blanking plate should be fitted in the top

outlet.

Ducting:

In order to obtain satisfactory air extraction,

long ducts should not be used. Pipes with a

minimum internal diameter of 100mm and

with as smooth an inner wall as possible are

recommended. The ducting MUST be

manufactured from a fire retardant material.

Fig.4

Fig.5

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire