Hotpoint BCB 7030 AA Guide de l'utilisateur Page 3

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 3
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 2
400011244385
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website docs . hotpoint . eu
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The control panel is
switched o, the appliance
does not work.
There may be an appliance power
supply problem.
Check that:
there is not a power outage;
the plug is properly inserted in the power socket and the mains
double-pole switch (if present) is in the correct position (i.e. allows
the appliance to be powered);
the household electrical system protection devices are ecient;
the power cable is not damaged.
The appliance could be in On/stand by
mode.
Turn the appliance on by briey pressing the “Temp.” button (see On/
Stand-by function).
The inside light does not
work.
The light may need to be replace.
Malfunction of a technical component.
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
The inside light ashes. Door alarm active.
It is activated when the refrigerator
compartment door remains open for a
prolonged period of time.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
The temperature inside the
compartments is not low
enough.
There could be various causes (see
“Solutions”).
Check that:
the doors close properly;
the appliance is not installed near a heat source;
the set temperature is adequate;
the circulation of air through the vents at the bottom of the
appliance is not obstructed (see installation section).
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked. Clean the defrosting water drain (see section “Cleaning and
Maintenance").
Excessive amount of frost in
the freezer compartment
The door of the freezer compartment
does not close properly.
Check that there is nothing preventing the door from closing
properly.
Defrost the freezer compartment.
Make sure the appliance has been correctly installed.
The front edge of the
appliance, at the door striker
seal, is hot.
This is not a defect. It prevents
condensation from forming.
No solution is necessary.
One or more green symbols
are ashing continuously
and it is not possible to
change the temperature set.
Malfunction alarm.
The alarm indicates a fault in a technical
component.
Contact Technical Assistance Service.
The temperature of the
refrigerator compartment is
too cold.
The set temperature is too cold.
A large amount of fresh food may
have been placed in the freezer
compartment.
Try to set a less cold temperature.
If fresh food has been placed in the freezer compartment, wait
until it has fully frozen.
Turn o the fan (if present) following the procedure described in
the paragraph “FAN.
* Available only on certain models
Vue de la page 2
1 2 3

Commentaires sur ces manuels

Pas de commentaire