Hotpoint FFA52S Mode d'emploi Page 10

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 9
10
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
Troubleshooting
If the appliance does not work, before calling for Assistance (
see Assistance
), check for a solution from the following list.
Malfunctions:
The POWER indicator light does not
illuminate.
The refrigerator and the freezer do
not cool well.
The food inside the refrigerator is
beginning to freeze.
The motor runs continuously.
The appliance makes a lot of noise.
There is water at the bottom of the
refrigerator.
Possible causes / Solutions:
The plug has not been inserted into the electrical socket, or not far
enough to make contact, or there is no power in the house.
The doors do not close properly or the seals are damaged.
The doors are opened too frequently.
The TEMPERATURE ADJUSTMENT knob is not in the correct position
The refrigerator or the freezer have been over-filled.
The TEMPERATURE ADJUSTMENT knob is not in the correct
position.
The food is in contact with the back inside wall of the refrigerator.
The door is not closed properly or is continuously opened.
The outside ambient temperature is very high.
The thickness of the frost exceeds 2-3 mm (
see Maintenance
).
The appliance has not been installed on a level surface (
see
Installation
)
.
The appliance has been installed between cabinets that vibrate and
make noise.
The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
The water discharge hole is blocked (
see Maintenance
).
Don’t forget should our advice fail to resolve the problem with your appliance please call us on 08448 224
224 to arrange an engineer visit. Or visit
www.hotpointservice.co.uk
Product failures are fully covered by your 12 months parts and labour guarantee. However, if we attend and
there is no product failure or the failure has been caused by damage, misuse or by incorrect installation,
charges will apply.
Vue de la page 9
1 2 ... 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire