Hotpoint E320SKIX Mode d'emploi télécharger pdf (Page 4)

Instructions for the installer

Installation

These instructions are turned to the skilled installer as

a guide toinstallation, regulationand maintenance in

compliance with the lawsand the rules in force. Any of

these operationsmust always be carriedout when the

appliancehas been disconnected from the electric

system.

Positioning (Fig. 4)

The apparatus isprovided to be built-in awork-top

as shown in thespecial ﬁgure.Present the sealing

agentalong all the perimeter.

Electrical connection (Fig. 5)

Before carrying out theelectrical connection be sure that:

- the characteristics of the system are such as tosatisfy

what indicated onthe part number plateapplied to the

bottom ofthe work-top;

- that the system is provided with the effective ground

in compliance with the rules and the provisions of law

in force. The ground is binding according to the law.

In case the apparatus isn’tprovided with cable and/or

with relative plugmake use of material suitable for the

absorption indicated inthe part number plate andfor

the workingtemperature. The cableshould reach in

no point atemperature higher 50°Cthan of the room

temperature.

If connecting directly to the mains power supply, ﬁt a multi-

poles witch of a suitable size for the rated capacity with

a clearance distance which completely disconnects the

power line under over voltage category III conditions,

consistently with the rules of installation (the yellow/green

earth wire must not be interrupted).

The plug on the omnipolarswitch should be easilyreachable

with apparatusinstalled.

N.B.: - The manufacturer declines all responsibilityin case

the above and the usual safety rules aren’trespected.

To avoid all risk, if the powercable becomes damaged,

it mustonly be replaced bythe manufacturer, byan

authorised service centre, or by aqualiﬁed electrician.

1 2 3 4 5 6 7

Pas de commentaire

Hotpoint E320SKIX Mode d'emploi Page 4