Hotpoint G740 Manuel d'utilisateur télécharger pdf (Page 9)

• On completing the operation, replace the old rating label with

the one showing the new type of gas; the sticker is available

from Hotpoint Service (see KEY CONTACTS, back page).

If the gas pressure is different than that prescribed, a pressure

regulator must be installed at the source, in compliance with

national standards governing the use of piped gas regulators.

Regulation of Air Supply to the Burner

The burners do not need a primary air regulator.

Minimum Regulation

• Turn the gas valve to minimum.

• Remove the knob and turn the regulator screw (positioned

either on the side of the top or inside the shaft) clockwise

until the flame becomes small but regular.

N.B.: In the case of liquid gas, the regulation screw must be fully

screwed in (clockwise).

• Make sure that, when the knob is turned rapidly high to low,

the flame does not go out.

Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Hotpoint G740 Manuel d'utilisateur Page 9