Hotpoint FFQ50P Manuel d'utilisateur télécharger pdf (Page 11)

Troubleshooting

Malfunctions:

The green POWER indicator light does

not illuminate.

The motor does not start.

The indicator lights are on but the light

is dim.

a) The alarm sounds.

b) The alarm sounds and the two

yellow indicator lights flash.

c) The alarm sounds and the two

yellow indicator lights as well as the

green one flash.

The AQUA CARE LED flashes slowly

The blocked water is drained and the

AQUA CARE LED flashes quickly

The blocked water is drained, the

AQUA CARE LED is switched off and

the alarm sounds

The green POWER indicator light

flashes.

The refrigerator and the freezer do not

cool well.

The food inside the refrigerator is

beginning to freeze.

Possible causes / Solutions:

 The plug has not been inserted into the electrical socket, or not far enough

to make contact, or there is no power in the house.

 The appliance comes with a motor protection control (see Start-up and use).

 Pull out and reverse the plug before putting it back in the socket.

a) The refrigerator door has remained open for more than two minutes (the

buzzer will stop sounding when you shut the door) or the correct

switching-off procedure was not followed (see Maintenance).

b) The temperature in the freezer is too high. Check the quality of the food

products and dispose if necessary.

c) The temperature in the freezer has reached a dangerous level. The food

must be disposed immediately.

b/c) In the first case the freezer will maintain a temperature of about 0°C so

that the food does not re-freeze. In the second case, however, the

temperature will remain at approximately -18°C.

To turn off the acoustic signal open and close the refrigerator door. To

restore normal operation bring the FREEZER OPERATION knob setting

(off) and turn the appliance on again.

 The Aqua Care filter is about to wear out

 The Aqua Care filter is worn out and needs to be replaced (see

Maintenance and care)

 The Aqua Care safety blocking system has been activated due to

prolonged supply (5 consecutive minutes). To reset the alarm, simply

release the dispenser button. To silence the alarm, open and close the

door.

 The appliance is not operating correctly. Contact the Technical Assistance

Centre.

 The doors do not close properly or the seals are damaged.

 The doors are opened too frequently.

 The OPERATION knobs are not on the correct setting (see Description).

 The refrigerator or the freezer have been over-filled.

 The REFRIGERATOR OPERATION knob is not on the correct setting (see

Description).

 The food is in contact with the back inside wall of the refrigerator.

Heating

danger

Heating

is excessive

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint FFQ50P Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs-congélateurs côte à côte Hotpoint FFQ50P