Hotpoint EG74 Manuel d'utilisateur télécharger pdf (Page 28)

Electrical Connection

Warning - THIS APPLIANCE MUST BE EARTHED

The cooker must be connected by a qualified electrician to a suitable double -

pole control unit with a minimum rating of 32A and a minimum contact clearance

of 3mm, which should be fitted adjacent to (but not above) the cooker, in

accordance with IEE regulations.

The power supply cable should conform to BS6004 with a conductor size of

4mm

The control unit should be easily accessible in the event of an emergency.

This appliance conforms to EN55014 regarding suppression of radio and

television interference.

The cooker terminals are behind the cover at the rear. The mains cable must

pass through the cable clamp and the screws must be fully tightened.

Sufficient cable should be used to allow the cooker to be pulled out for

servicing. Ensure that the cover is fully closed and secure afterwards.

Take care not to trap the mains cable when pushing the cooker into its final

position.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Hotpoint EG74 Manuel d'utilisateur Page 28