15
ELECTRICAL CONNECTIONS
The electrical connection must be made before connecting the
appliance power cable to the electricity supply. The appliance
must be installed by a qualified electrician who is fully aware of
statutory safety and installation regulations. Specifically,
installation must be carried out in compliance with the
regulations of the local electricity company. Make sure that the
voltage shown on the rating plate is the same as the power supply
voltage in your home. The appliance must be earthed in
compliance with the provisions of law: use exclusively conductors
(including the earth conductor) of the appropriate size. The
manufacturer declines all liability for injury to persons or animals
and for damage to property resulting from failure to observe the
above regulations. For the electrical connection use an HO5 RR-F
type cable as indicated in the table below:
Power supply voltage.
If the cooktop is supplied with a power cable already
fitted, see the diagram on the Product Description Sheet
for connection to the mains electricity supply.
The appliance must be connected to the electricity supply
via an all-pole disconnect switch with minimum contact
gap of 3 mm.
Caution
: the power supply cable must be long enough to allow
the cooktop to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Connecting to the terminal board
Note
: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
•
Place the glass-ceramic hob on a soft cloth to prevent it from
being scratched during the installation procedure
•
Unscrew cover (A) fixed to the underside of the cooktop
•
Remove an approximate length of 70 mm of the power cable
insulation
•
Strip approximately 10 mm of insulation from the wires then
insert the power cable into cable clamp (B) and connect the
wires to terminal board (C) as shown in the wiring diagram
alongside the terminal board.
•
Secure the power cable with cable clamp (B)
•
Close the terminal board with cover (A)
•
Once the power cable has been connected to the appliance,
fit the cooktop from above the worktop and hook it to the
support springs as shown in the figure.
Whenever the cooktop is connected to the mains it performs an
automatic check lasting several seconds.
Conductors Number x size
230V ~
+
3 x 4 mm
2
230-240V ~
+
3 X 4 mm
2
(Australia only)
230V 3~
+
4 x 1.5 mm
2
400V 3N ~
+
5 x 1.5 mm
2
400V 2N ~
+
4 x 1.5 mm
2
power cable
soft cloth under the
class ceramic hob
cooktop base
31902035GB.fm Page 15 Tuesday, May 22, 2007 4:24 PM
(12 pages)
(24 pages)
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels