Hotpoint AKT 808/NE Mode d'emploi Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
69
BEFORE USING THE GLASS-CERAMIC
COOKTOP
CAUTION: This cooktop complies with all
applicable safety and electromagnetic
compatibility legislation.
However, persons with pacemaker should
keep at a safe distance from the appliance.
This is because it is not possible to guarantee
that all pacemakers on the market comply
with the standards in compliance with which
this appliance was tested so it is not possible
to provide an absolute guarantee of the
absence of potentially harmful interference.
To make the most of your new appliance,
please read the user instructions carefully and
keep them handy for future consultation.
INSTALLATION
Cooktop
The cooktop must be set into a worktop the thickness
of which must be between 30 mm and 50 mm
For the distance between the underside of the glass-
ceramic cooktop and the cupboard or separating panel
beneath it, observe the dimensions given in figure “A”.
If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop.
Cut an opening in the worktop of the dimensions shown in the
Product Description Sheet supplied separately.
Apply the supplied gasket to the cooktop (unless it has already
been fitted), after having cleaned the surface.
Important
In order to prevent the electronic circuits from overheating with
consequent damage, we recommend the following:
Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do not
come into contact with steam or moisture, which could
damage them.
If an oven (manufactured by us) is to be installed under the
cooktop, ensure it is equipped with a cooling system and observe
the distances given in figure “B”. There must be nothing
between the cooktop and the oven (cross rails, panels, brackets,
etc.).
If the oven has a self-cleaning function (pyrolysis), do not use the
cooktop whilst this function is selected.
If the temperature of the electronic circuits exceeds the
maximum permitted value, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a tolerable
level, at which point it will be possible to switch the cooktop on
again.
Switch the cooktop off after use.
Rear wall
Front
A
B
Vue de la page 1
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire