Hotpoint BLZE 6290/IN Mode d'emploi Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 7
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
12
INSTALLATION
ELECTRICAL CONNECTION
•Important:
do not connect the oven to the power
supply until you have completed the electrical
connection.
Make sure the appliance is installed and connected to
the electricity supply by a qualified technician in
accordance with the manufacturer's instructions and in
compliance with local regulations.
The installer is responsible for connecting appliances
correctly to the mains and for observing the safety
regulations.
The appliance must be connected to the electricity
supply by means of an all-pole disconnect switch with
minimum contact gap of 3 mm.
Regulations require that the appliance be earthed.
Do not use multiple adapters or extension leads.
After the oven has been installed, electrical parts must
be inaccessible.
In case of connection with plug, make sure it is
accessible after installation of the appliance.
Make sure that the voltage stated on the appliance
rating plate is the same as the voltage in your home.
The rating plate is on the front edge of the oven cavity
(visible with oven door open).
When replacing the power cable, use a cable type
H05RR-F 3x1.5 or higher.
Technical information for the installer
This appliance is extremely heavy. Accordingly, it must be lifted and handled by two or more people in order to
any avoid risk or injury.
After removing the oven from its packaging, before making the connections place it on the polystyrene foam base
to protect it from damage.
Do not attempt to lift the oven by the handle (Fig. 1, A) but grip it at the sides (Fig. 1, B)
Check that the appliance has not been damaged in transit.
Oven and housing dimensions are shown in the figure opposite.
Kitchen units in contact with the oven must be heat resistant (min. 85°C).
If plastic laminates or sealants are not sufficiently heat-resistant, warping, bubbling or detachment of the finish may result.
Insert the oven in the housing, lifting it at the sides and making sure that the supply cable is not trapped.
Secure the oven using the screws provided.
The oven can also be installed in a column unit.
To allow for proper ventilation, provide an opening measuring at least 860x90 mm on the bottom of
the housing. If installed in a column unit, in addition to the 860x90 mm opening, provide a further
opening on the top of the column measuring 500x90 mm.
Fig. 1
Vue de la page 1
1 2 3 4 5 6 7

Commentaires sur ces manuels

Pas de commentaire