Hotpoint BTSZ 1631/HA Mode d'emploi télécharger pdf (Page 15)

Troubleshooting

If the appliance does not work, before calling for Assistance (see Assistance), check for a solution from the following list.

Malfunctions:

The internal light does not

illuminate.

The refrigerator and the freezer do

not cool well.

The food inside the refrigerator is

beginning to freeze.

The motor runs continuously.

The appliance makes a lot of noise.

The back wall of the refrigerator unit

is covered in frost or droplets of

water.

There is water at the bottom of the

refrigerator.

Possible causes / Solutions:

 The plug has not been inserted into the electrical socket, or not far

enough to make contact, or there is no power in the house.

 The door do not close properly or the seals are damaged.

 The door are opened too frequently.

 The TEMPERATURE ADJUSTMENT knob is not in the correct position

 The refrigerator or the freezer have been over-filled.

 The atmospheric temperature of the area surrounding the appliance is

lower than 14°C.

 The TEMPERATURE ADJUSTMENT knob is not in the correct position.

 The food is in contact with the back inside wall of the refrigerator.

 The door is not closed properly or is continuously opened.

 The outside ambient temperature is very high.

 The appliance has not been installed on a level surface (see Installation).

 The appliance has been installed between cabinets that vibrate and

make noise.

 The internal refrigerant makes a slight noise even when the compressor

is off. This is not a defect, it is normal.

 This shows the appliance is operating normally.

 The water discharge hole is blocked (see Maintenance).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Hotpoint BTSZ 1631/HA Mode d'emploi Page 15