Hotpoint KIT 641 F B Mode d'emploi télécharger pdf (Page 7)

EN8

Timer

The timer can be used to set the cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all the cooking zones.

Select the cooking zone to be used with the timer, press the timer and a beep signals the function (see figure). The display shows “00” and the LED indication

comes on. The Timer value can be decreased and increased by keeping the slider function “+” and “-” buttons pressed. When the set time has elapsed, an acoustic

signal sounds and the cooking zone switches off automatically. To deactivate the timer, keep the Timer button pressed for at least 3 seconds.

To set the timer for another zone, repeat the above steps. The timer display always shows the timer for the selected zone or the shortest timer.

To modify or deactivate the timer, press the cooking zone selection button for the timer in question.

Control panel warnings.

AUTOMATICS FUNCTIONS

Eco Booster

This function brings the water to the boil and maintains boiling, avoiding spilling, with a reduction of energy consumption.

After positioning the pot on the cooking zone, switch on the hob and select the cooking zone. To enable the function, press the

button. To deactivate the

function, simply press

button.

To optimize this control and ensure the best energy saving, it is advisable to use a pot with bottom width similar to that of the selected cooking zone. The quality of the

pot used, the presence or absence of the lid or salt, can affect the performance of the function. 2 to 3 liters of water (preferably at room temperature) is recommended,

and its advisable not to use the lid. In any case it is advisable to keep a check on the boiling conditions and the amount of residual water.

Simmering

After bringing to the boil, press the key and the hob will automatically set the correct power level to keep the pot simmering. “A” appears on the display: the

indicator light lights up. To deactivate the function, simply press

button.

Melting

This function maintains a permanently low temperature in the cooking zone. After positioning the pot/accessory on the cooking zone, switch on the hob and select the

cooking zone. Press the

key: “A” appears on the display and the indicator light turns on. To deactivate the function, simply press button

RESIDUAL HEAT IN DICATOR.

The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.

If the display shows

, the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a

dish warm or to melt butter.

When the cooking zone cools down, the display goes off.

INCORRECT OR MISSING POT INDICATOR.

If you are using a pot that is not suitable, not correctly positioned or not of the correct dimensions for your induction hob, the message “no pot” will

appear in the display (see figure at side). If no pot is detected within 60 seconds, the hob switches off.

FAST BOIL FUNCTION (BOOSTER)

This function, only present on some cooking zones, makes it possible to exploit the hob’s maximum power (for example to bring water to the boil very quickly). To

activate the function, press the “+” button until “P” appears on the display. After 10 minutes’ use of the booster function, the appliance automatically sets the zone to

level 9.