Hotpoint WASHER-DRYER WDPG Manuel d'utilisateur télécharger pdf (Page 8)

How to run a wash cycle or a

drying cycle

1. SWITCH THE MACHINE ON. Press the button; the

START/PAUSE indicator light will flash slowly in a green

colour.

2. LOAD THE LAUNDRY. Open the porthole door. Load

the laundry, making sure you do not exceed the maximum

load value indicated in the table of programmes and wash

cycles on the following page.

3. MEASURE OUT THE DETERGENT. Pull out the

detergent dispenser drawer and pour the detergent into

the relevant compartments as described in “Detergents

and laundry”.

4. CLOSE THE DOOR.

5. SELECT THE WASH CYCLE. Use the WASH CYCLE

SELECTOR knob to select the desired wash cycle. A

temperature and spin speed is set for each wash cycle;

these values may be adjusted. The duration of the cycle will

appear on the display.

6. CUSTOMISE THE WASH CYCLE. Use the relevant buttons:

Modify the temperature and/or spin speed. The

machine automatically displays the maximum temperature

and spin speed values set for the selected cycle, or the

most recently-used settings if they are compatible with

the selected cycle. The temperature can be decreased by

pressing the button, until the cold wash “OFF” setting

is reached. The spin speed may be progressively reduced

by pressing the button, until it is completely excluded

(the “OFF” setting). If these buttons are pressed again, the

maximum values are restored.

Setting the drying cycle

The first time the button is pressed, the machine will

automatically select the maximum drying cycle which is

compatible with the selected wash cycle. Subsequent

presses will decrease the drying level and then the drying

time, until the cycle is excluded completely (“OFF”).

Drying may be set as follows:

A- Based on the desired laundry dryness level:

Iron “A1”: suitable for clothes which will need ironing

afterwards. the remaining dampness softens creases,

making them easier to remove.

Hanger “A2”: ideal for clothes which do not need to be

dried fully.

Cupboard “A3”: suitable for laundry which can be put

back in a cupboard without being ironed.

Extra “A4”: suitable for garments which need to be dried

completely, such as sponges and bathrobes.

B - Based on a set time period: between 30 and 180

minutes.

If your laundry load to be washed and dried is much

greater than the maximum stated load, perform the wash

cycle, and when the cycle is complete, divide the garments

into groups and put some of them back in the drum. At this

point, follow the instructions provided for a “Drying only”

cycle. Repeat this procedure for the remainder of the load.

A cooling-down period is always added to the end of each

drying cycle.

Drying only

Use the cycle selector knob to select a drying cycle (12-13-14)

in accordance with the type of fabric. The desired drying level or

time may also be set using the DRYING button .

Selecting the cotton drying cycle through the programme

selector knob and pressing the “Eco” button activates an

automatic drying cycle that allows for saving energy, thanks

to an optimal combination of air temperature and cycle

duration; the display will visualise the “A2” dryness level.

Set the desired wash intensity.

Option makes it possible to optimise washing based

on the level of soil in the fabrics and on desired wash cycle

intensity.

Select the wash programme: the cycle will be automatically

set to “Normal” as optimised for garments with an average

level of soil (this setting is not applicable to the “Wool”

cycle, which is automatically set to “Delicate”).

For heavily-soiled garments press button until the

“Intensive” level is reached. This level ensures a high-

performance wash due to a larger quantity of water used

in the initial phase of the cycle and due to increased drum

rotation. It is useful when removing the most stubborn

stains.

For lightly-soiled garments or a more delicate treatment

of the fabrics, press button until the “Delicate” level

is reached. The cycle will reduce drum rotation to ensure

washing results that are perfect for delicate garments.

Modify the cycle settings.

• Press the button to enable the option; the indicator light

corresponding to the button will switch on.

• Press the button again to disable the option; the

indicator light will switch off.

! If the selected option is not compatible with the set wash

cycle, the indicator light will flash and the option will not be

activated.

! If the selected option is not compatible with a previously

selected one, the indicator light corresponding to the first

function selected will flash and only the second option will

be activated; the indicator light for the option which has been

activated will be illuminated.

! The options may affect the recommended load value and/

or the duration of the cycle.

7. START THE WASH CYCLE. Press the START/PAUSE

button. The corresponding indicator light will turn green,

remaining lit in a fixed manner, and the door will be locked (the

DOOR LOCKED symbol will be lit). To change a wash

cycle while it is in progress, pause the washer-dryer using the

START/PAUSE button (the START/PAUSE indicator light will

flash slowly in an amber colour); then select the desired cycle

and press the START/PAUSE button again. To open the door

while a cycle is in progress, press the START/PAUSE button; if

the DOOR LOCKED symbol is switched off the door may

be opened. Press the START/PAUSE button again to restart

the wash cycle from the point at which it was interrupted.

8. THE END OF THE WASH CYCLE. This will be indicated

by the text “END” on the display; when the DOOR LOCKED

symbol switches off the door may be opened. Open the

door, unload the laundry and switch off the machine.

! If you wish to cancel a cycle which has already begun, press

and hold the button. The cycle will be stopped and the

machine will switch off.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WASHER-DRYER WDPG Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Rondelles Hotpoint WASHER-DRYER WDPG