Hotpoint WMM65 Manuel d'utilisateur télécharger pdf (Page 25)

Troubleshooting...

The ‘Time to End’ display jump...

● The estimated programme times are

dependant on the temperature and

pressure of the incoming water supply,

the option(s) selected and the load being

washed. They may, therefore change

during the fill stages of each programme

to take into account the extra heating or

fill time required.

The programme takes a long time...

● Some programmes do take a long time.

Things which can lengthen the

programme time include low

temperature and low pressure of the

incoming hot water supply, or low cold

water pressure.

The machine makes a noise or vibrates

during a spin programme...

If the noise is very loud you should check

whether:

i) You have removed the transit bolts.

ii) You have removed the polystyrene block.

iii)You have correctly adjusted the feet to

stabilize the machine.

iv)You have removed loose items such as

coins from pockets, as these can rattle

about inside the machine drum and

cause damage.

The laundry has not spun dry...

● Is the ‘Spin’ progress status light flashing?

If so, see the next section,‘The ‘Spin’

progress status light is flashing’.

● Did you use a short spin programme?

If so, try again using a faster spin

programme.

● Did you reduce the spin speed of the

selected programme using the ‘Variable

Spin’ option control button?

If so, select a faster spin programme.

● Did you use the ‘F.Fwd’ option and

skipped through the spin cycle?

If so select a Spin only programme.

The ‘Spin’ progress status light is

flashing...

● This means that there has been an

unbalanced load and the machine could

not spin.

See ‘Unbalanced Load Warning’in the

PROGRAMMES & OPTIONS section.

Water collects in the detergent

dispenser compartment...

● Is the retaining flap in the down position.

Lift to allow the water to drain away.

The dispenser drawer will not close

properly...

● Please check that the drawer is properly

aligned.

● Is the drawer clogged with detergent?

(see: CLEANING & MAINTENANCE).

Steam is coming from the dispenser

drawer...

● We have designed the machine to release

steam from the dispenser drawer during

hot washes, so don’t worry.

Suds are coming from the dispenser

drawer...

● Have you used the correct low suds

automatic detergent?

See ‘The Dispenser’ - Choose a suitable

detergent.

● If you have used the wrong type of

detergent, flush out your machine by

choosing a rinse programme.

Not all of the detergent has been flushed

away...

● Check that your water supply taps are

turned on fully.

● Check the inlet hoses are not kinked.

● Is your hot water pressure low? If so

you may need a cold fill adaptor to run

your machine as cold fill only.

● Ensure the detergent flap is in its ‘up’

position when dispensing powder and

‘down’ for dispensing liquid.

The flap keeps falling down...

● As you push the flap to the up position

you will feel some resistance, increase the

pressure and the flap will move to its

home position.

If the machine is still not working contact

Hotpoint Service, see the back page.

Remember, you may be charged for a

service call if a problem with your

machine is caused by incorrect

installation or misuse.

25

TROUBLE

SHOOTING

1 2 ... 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire