Hotpoint WDL 5490 P (UK) Mode d'emploi télécharger pdf (Page 2)

Installation

! Keep this instruction manual in a safe place for future

reference. Should the appliance be sold, transferred or

moved, make sure the instruction manual accompanies the

washing machine to inform the new owner as to its opera-

tion and features.

! Read these instructions carefully: they contain vital

information on installation, use and safety.

Unpacking and levelling

Unpacking

! This is a separate part

of the polystyrene base

and should be removed

with the base.

! IMPORTANT check when

unpacking your machine.

1. Unpack the washing machine.

2. Check whether the washing machine has been dama-

ged during transport. If this is the case, do not install it

and contact your retailer.

3. Remove the 4 protective

screws and the rubber bush

with the respective spa-

cer, situated on the rear of

the appliance (see also the

installation leaflet).

4. Seal the gaps using the plastic plugs provided.

5. Keep all the parts: you will need them again if the wa-

shing machine needs to be moved to another location.

! Packaging materials are not children’s toys.

Levelling

Your machine may make a considerable amount of noise if the

two front feet have not been adjusted correctly.

1. Install the washing ma-

chine on a flat sturdy floor,

without resting it up against

walls, furniture cabinets or

other.

2. If the floor is not perfectly level, compensate for any

unevenness by tightening or loosening the adjustable

front feet (see figure); the angle of inclination, measu-

red according to the worktop, must not exceed 2°.

Levelling your appliance correctly will provide it with

stability and avoid any vibrations, noise and shifting du-

ring operation. If it is placed on a fitted or loose carpet,

adjust the feet in such a way as to allow enough room

for ventilation beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply pipe

by screwing it to a cold

water tab using a

3/4 gas threaded connec-

tion (see figure).

Before performing the

connection, allow the wa-

ter to run freely until it is

perfectly clear.

2. Connect the other end of

the water inlet hose to the

washing machine,

screwing it onto the ap-

pliance’s cold water inlet,

situated on the top right-

hand side on the rear of the

appliance(see figure).

3. Make sure there are no kinks or bends in the hose.

! The water pressure at the tap must be within the

values indicated in the Technical details table

(on the next page).

! If the water inlet hose is not long enough, contact a

specialist store or an authorised serviceman.

! Ensure that the supply taps are allowing water throu-

gh. Old taps may seize in the closed position and thus

prevent water reaching the machine.

1 2 3 4 5 6 7 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint WDL 5490 P (UK) Mode d'emploi Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à laver Hotpoint WDL 5490 P (UK)