Hotpoint WMSL 501P UK Mode d'emploi télécharger pdf (Page 14)

The machine leaks (other than

dispenser).

The indicator lights on the console

are flashing rapidly.

The machine smells.

The machine door cannot be

opened.

Door Seal damaged at the bottom.

The water level is too low when

the machine is washing.

There is too much foam.

After completing the programme, or

before starting a programme, the ma-

chine has turned itself off (no lights).

General.

• The fill hose is loose, check both the cabinet and tap ends.

• The fill hose is tight but still leaks, if so replace the rubber washers, or the fill

hose is missing the rubber washer.

• The drain hose is not fixed in properly.

• Switch off the machine and unplug it, wait for approximately 1 minute and then switch it

back on again If the problem persists contact the Technical Assistance Service.

• The machine requires a service wash. Run a “Auto Clean” wash cycle with

detergent and no laundry.

• The door will not open until the door lock indicator light goes out shortly after

the program has finished.

• The door seal has drainage holes at the bottom - This is normal.

• The water level is correct if it can be seen at the bottom of the door.

• The detergent is not suitable for machine washing (it should display the text

‘for washing machines’ or ‘hand and machine wash’ or the like).

• Too much detergent was used - less detergent is required in soft water.

• To comply with new energy saving regulations the machine is fitted with an

automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate

the machine, it can then either be switched off or a new programme selected.

• Your washing machine contains sensors that monitor progress during the wash

cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress).

Normally, if your machine successfully completes the cycle, there is unlikely to

be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying con-

tents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not have a

wash label, or wash items that are not intended as machine washable.

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

Hotpoint WMSL 501P UK Mode d'emploi Page 14