Hotpoint WMTL 80 (UK) Mode d'emploi télécharger pdf (Page 7)

5. Connect to the Water Supply...

●

Water inlet: Minimum water pressure: 0.05 MPa or 0.5 bars

Maximum water pressure: 1MPa or 10 bars

●

The temperature of the incoming household hot water supply should ideally be 60°C and no

higher than 70°C as this could cause damage to both your laundry and appliance.

●

The water supply taps must be easily accessible when the appliance is installed.

●

The appliance must be connected to the appliance water supply using the new hose set

supplied,old hose sets should not be used.

WARNING

●

Do not connect

appliance to a single

outlet instantaneous

water heater.

Hot and Cold Water Supply

Both hot and cold fill hoses are supplied with your machine - packed in the drum for

transit:

1. Connect the angled end of the RED marked hose to the RED plastic inlet valve at the

back of the appliance.Connect the straight end to your HOT water supply.

2. Repeat the procedure connecting the angled end of hose without a mark to the

WHITE inlet valve at the back of the appliance and the straight end to your COLD

water supply.

3. Hand tighten connectors sufficiently to ensure water does not leak from the hose

connections.

4. Turn on water supply taps and check for leaks from the connectors.In the event of a

leak,turn off supply tap,remove connector and check sealing washer is in place.

Refit connector and tighten.Turn on water supply taps.

Remember you may be

charged for a service

call if a problem with

your appliance is

caused by incorrect

installation or misuse.

Cold Water Adaptor

If you have no hot water

supply or your hot water

pressure is low...you can use

a cold fill adaptor.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Hotpoint WMTL 80 (UK) Mode d'emploi Page 7