Hotpoint EDC51 Manuel d'utilisateur télécharger pdf (Page 23)

1. Plastic or nylon pads / scourers, these may scratch the surface.

2. Household abrasive powders.

3. Oven chemical cleaners, aerosols and oven pads.

Caustic cleaners such as these will etch the surface and attack the

metal frame.

4. Bath and sink cleaners may mark the surface.

To reduce the amount of cleaning always ensure that the hob and cooking

utensils are clean and dry before use. Regular use of cleaner conditioner

is recommended for proper care and protection of the hob surface.

Apply conditioner before using the hob for the first time. It contains a

mild cleaning agent, so that subsequent applications may clean off soil

and apply a protective film at the same time. For stubborn stains or

heavy soiling use any of the following materials, and finish off with

conditioner.

1. Cif, non-scratch scouring cream.

2. Liquid Gumption Kitchen Cleanser.

3. Special Powder Cleanser.

Powder Cleanser – Mineral deposits that are present in hard water, and

some foods, may cause ‘discolourations’ that appear in the form of grey

or brown stains. The stains sometimes appear to be in or under the glass

surface. If there are some persistent stains after using any of the other

recommended cleaning materials, powder cleanser may be applied, fol-

lowing the manufacturers instructions. Do not use abrasive cleaners or

the powder cleanser on the painted metal framework.

Cleaner Conditioner – Regular use of the conditioner will make the sur-

face easier to clean thus ensuring that years of heavy abrasive cleaning

do not progressively dull the surface.

Care and Cleaning

TURN OFF THE MAIN SWITCH BEFORE CLEANING.

BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS

ARE IN THE OFF POSITION.

NEVER USE BIOLOGICAL WASHING POWDER, HARSH

ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR OVEN

CHEMICAL CLEANERS OF ANY KIND UNLESS

SPECIFIED BELOW.

Cleaning materials

to avoid

Ceramic hob

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Hotpoint EDC51 Manuel d'utilisateur Page 23