Hotpoint RGB747GER Manuel d'utilisateur télécharger pdf (Page 43)

5.

To

prevent leakage, make sure the orifice

spuds are securely screwed into the gas inlet

tubes. Use a small wrench to hold the inlet tube

hex to prevent it from twisting.

6. Put old

oritice

spuds back in the bag to save

for possible future conversion.

Note: If an orifice spud is accidentally

dropped, the cooktop

can be

r~sed

by

“engag’ng

e

the 2 front clips

with a large flat

blade screwdriver.

DO NOT attempt to raise the cooktop without

removing all 4 burner bases.

If wires were disconnected to remove the

cooktop, feed wires through the burner holes in

the cooktop. Attach to each burner electrode

terminal carefully, making sure not to bend the

terminal. Then lower cooktop until it snaps

over the clips.

Electrode

----

7. Carefully insert burner bases straight down

with the tube over the orifice spud. Replace the

screws,

making sure the tall screw is

opposite the burner electrode in each

burner base.

❑

CONVERT THE OVEN BURNER ORIFICES

Oven Burner

1.

Remove oven door, storage drawer or broiler

drawer, oven bottom and burner baffle. The

lower burner orifice spud is located behind the

storage drawer, broiler drawer or kick panel. (On

some models, a metal shield must be removed to

access the orifice.)

2.

To convert to LP gas,

use a 1/2” wrench to turn

the lower burner orifice

spud clockwise. Tighten the

spud only until it is snug.

To prevent damage, do

not overtighten the spud.

To convert to natural gas,

loosen the spud about 2 turns.

Broil Burner

To convert to LP gas,

use a 1/2” wrench to

turn the upper burner orifice spud clockwise.

Tighten spud only until it is snug with the base.

To prevent damage, do not overtighten spud.

To convert to natural gas,

loosen the spud

about 2 turns.

(continued rwxt page)

43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Commentaires sur ces manuels

Pas de commentaire