Hotpoint BCI480.C Mode d'emploi télécharger pdf (Page 8)

8

D

1509)50-4

First of all.

- Turn on the water supply

tap completely.

- Add the correct amount of

detergent.

- Load the baskets cor-

rectly.

- Check that the spray

arms rotate freely.

- Close the door securely.

-After performing all the op-

erations described in the pre-

vious paragraphs, open the

appliance door and press

ON-OFF button: the ON/OFF

indicator light comes on.

Your appliance is now on and

awaiting instructions.

Select the wash

cycle.

Select the wash cycle by

pressing “Wash Pro-

gramme Selector” button.

Each time this button is

pressed, one of the Cycle

indicator lights will come on

in sequence, select the wash

cycle most suitable for the

type of dishes to wash (see

‘Programme Chart’).

Close the door and after a

few seconds, you will hear a

short beep: the wash cycle

has begun.

AUTO WASH CYCLES: This

model of dishwasher is

equipped with a special sen-

sor which can be used to as-

sess the level of soiling and

automatically select the

most efficient and economic

wash cycle accordingly. The

duration of the auto wash

cycles may vary due to the

operation of the sensor.

Modifying a wash cy-

cle in progress.

If you have chosen the

wrong cycle - You can

modify the wash cycle in

progress, if it has only just

started. Open the appliance

door carefully to avoid any

hot water splashes, then

keep “Wash Programme

Selector”button, pressed for

approximately 5 seconds,

until you hear 3 short beeps.

The cycle Indicator light will

come off and at this point,

all the settings will have been

cancelled. You are now free

to re-set the correct wash cy-

cle.

You've left out a dish?

Interrupt the wash cycle by

opening the appliance door

with the utmost care, as

usual, then insert the dish

you had forgotten. When you

shut the appliance door, the

cycle will start up from where

you interrupted it.

Cycle end

The end of the wash cycle

is indicated by a double

beep and the flashing of the

wash cycle indicator light.

How to use your Dishwasher

There's been a

power failure or you

opened the

dishwasher door

The wash cycle stops and

then restarts when the

electricity comes back on or

when you close the door.

Delayed start

It is possible to delay the

start time of the cycle by 2,

4 or 6 hours.

1. Press the DELAYED

START button: every time

the button is pressed, a beep

is emitted and the selected

delayed start indicator light

illuminates.

2. Select the wash cycle and

shut the door: after the beep

sounds, the timer begins

counting down.

3. Once this time has

elapsed, the indicator light

switches off and the wash

cycle begins.

To adjust the delay time and

select a smaller period of

time, press the DELAYED

START button. To cancel it,

press the button repeatedly

until the selected delayed

start indicator light switches

off. The wash cycle will start

automatically as soon as the

door is shut.

Warning:

Open the dishwasher door,

press the ON-OFF button,

unplug the appliance from

the electricity socket to cut

off the power supply; the

power supply cable should

consequently be easily

accessible.

Turn off the water tap.

Wait a few minutes before

unloading the dishes: they

are very hot! If you wait a lit-

tle while, they dry better due

to the steam.

Empty the lower rack first.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire