Hotpoint DWF60 Manuel d'utilisateur télécharger pdf (Page 6)

CONNECT TO THE WATER SUPPLY...

● For your machine to operate correctly

it requires water pressures in the range

of 6-150 psi (100-1000 KPa).Most

cold water supplies will be in this

range.

● Ensure the fill hose is only connected

to the cold water supply.

WARNING

● Ensure the fill hose is NOT kinked.

Note: Do not over tighten the hose connec-

tor.Hand tight is sufficient.

● Tap connections (if applicable) - A

range of adaptors are available to suit

your tap.

WARNING

● Do not connect appliance to a single

outlet instantaneous water heater or

an electric heater.

Remember you may be charged for a

service call if a problem with your

appliance is caused by incorrect

installation or misuse.

CHECKLIST...

When you have installed your appliance,

ensure it is ready to use by following this

Check List:

1. Dispose of packaging safely, see

‘Recycling Information’ on page 2.

2. Position appliance close to

electrical/water supply see ‘Choose a

Location’on page 4.

3. Connect supplied hose to appliance

water supply, confirm water is flowing

before connecting to the appliance

inlet valve see ‘Connect to a Water

Supply’, page 6.

4. Untie drainage hose at rear of

appliance and connect to either a

standpipe or sink waste drainage

system see ‘Connect to a Drainage

System’page 5.

5. Untie mains lead at rear of appliance

and plug into electrical supply via a

switched socket, see ‘Electrical

Supply’ on page 3.

6. Position appliance, taking care not to

kink or damage hose at rear of

appliance.

7. Stabilise the appliance, see ‘Adjusting

the Feet’ page 4.

8. Turn on the water supply to the

appliance.

9. Switch on at plug socket.

Your appliance is now ready for use,refer to

‘Getting to know your Appliance’ on page 7 to

familiarise yourself with the appliance.

Installation...

6

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commentaires sur ces manuels

Pas de commentaire