Hotpoint SDW60P.C Mode d'emploi télécharger pdf (Page 6)

1509)50-4

Your free standing dishwasher can be installed in modern kitchens as follows:

●●

● to stand next to furniture units or other electric household appliances

(Please read the chapter on “Installation” in the instruction manual.)

● ●

● to insert or built-in under the one worktop.

Should it be necessary to remove the top shelf of the dishwasher, proceed as follows:

– Unscrew the 2 rear screws and then, with a light push forward, let it slide out and remove it (see fig.1)

– Discard the polystyrene rectangle.

– Open the door and, after unscrewing the fixing screws, remove the 3 plastic plugs used to hook the shelf on (fig. 2)

– Glue on the small soundproofing adhesive spongy strip onto the top crosspiece (photo 5) and, after tilting the appliance,

glue on another one underneath the base (photo 6).

– Straighten up the appliance and adjust the front and back feet by unscrewing them in an anti-clockwise direction to

raise the dishwasher to the required height.

– Insert the appliance underneath the worktop (fig.3), checking that the inlet and outlet pipes do not get bent or squashed

(please read the instructions provided in the “Installation” chapter). - The minimum distance between the sides of the

appliance and the side panels of the cabinet must be 2.5 mm at the very least*.

– Fix the dishwasher to the upper part of the recess using two self-tapping screws (fig. 4)..

–Open the dishwasher door and glue on the two equal-sized adhesive spongy strips on the front edge of the appliance

cabinet. Begin from the top without leaving out any spaces and make sure the strips adhere all along the length of the

edge. A small part of the spongy strip protruding onto the outside will block any light left between the dishwasher and

adjacent cabinets, thus improving the soundproofing.

Warning:

- Once the appliance has been installed, the electrical plug and socket should remain accessible.

- If the power supply cable is damaged, it must be replaced by the manufacturer or its Technical Assistance Service in

order to prevent all potential hazards. (See Assistance)

- The cable should not be bent or compressed.

- The Company shall not be held responsible for any incidents that occur if these regulations are not observed.

- The structure of your dishwasher makes it impossible to fit it under a hob.

INSTRUCTIONS FOR INSTALLING THE DISHWASHER IN FULLY-FITTED KITCHENS.

600

min.820

450

595

445

2,5mm*

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Pas de commentaire

Hotpoint SDW60P.C Mode d'emploi Page 6