Hotpoint HTDP120EDWW Manuel d'installation télécharger pdf (Page 8)

Installation Instructions

WATER SUPPLY REQUIREMENTS

Hot and cold water faucets MUST be installed within 42 in.

(107 cm) of your washer’s water inlet. The faucets MUST

EH  LQ  FP JDUGHQ KRVHW\SH VR LQOHW KRVHV FDQ

be connected. Water pressure MUST be between 10 and

120 pounds per square inch. Your water department can

advise you of your water pressure.

NOTE: A water softener is recommended to reduce buildup

of scale inside the steam generator if the home water

supply is very hard.

CONNECTING INLET HOSES (on some

models)

To produce steam, the dryer must connect to the cold

water supply. Since the washer must also connect to the

cold water, a “Y” connector is inserted to allow both inlet

hoses to make that connection at the same time.

NOTE: Use the new inlet hoses provided; never use old

hoses.

1. 7XUQWKHFROGZDWHUIDXFHWRȺ5HPRYHWKHZDVKHULQOHW

KRVHIURPWKHZDVKHU¿OOYDOYHFRQQHFWRUFROG

2. (QVXUHWKHUXEEHUÀDWZDVKHULVLQSODFHDQGVFUHZWKH

IHPDOHFRXSOLQJRIWKH VKRUWKRVHRQWRWKHZDVKHU¿OO

YDOYHFRQQHFWRU7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

3. Attach the female end of the ‘’Y’’ connector to the male

FRXSOLQJRIWKHVKRUWKRVH(QVXUHWKHUXEEHUÀDWZDVKHU

LVLQSODFH7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

4. ,QVHUW WKH ¿OWHU VFUHHQLQWKHFRXSOLQJRIWKHZDVKHU·V

LQOHW KRVH ,I D UXEEHU ÀDW ZDVKHU LV DOUHDG\ LQ SODFH

UHPRYHLWEHIRUHLQVWDOOLQJWKH¿OWHUVFUHHQ$WWDFKWKLV

coupling to one male end of the ‘’Y’’ connector. Tighten

E\KDQGXQWLO¿UPO\VHDWHG

5. (QVXUHWKHUXEEHUÀDWZDVKHULVLQSODFHDQGDWWDFKWKH

dryer’s long inlet hose to the other male end of the ‘’Y’’

FRQQHFWRU7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

6. (QVXUH WKH UXEEHU ÀDW ZDVKHU LV LQ SODFH DQG DWWDFK

WKH RWKHU HQG RI WKH GU\HU·V ORQJ LQOHW KRVH WR WKH ¿OO

valve connector at the bottom of the dryer back panel.

7LJKWHQE\KDQGXQWLO¿UPO\VHDWHG

CONNECTING INLET HOSES (cont.)

7. Using pliers, tighten all the couplings with an additional

two–thirds turn.

NOTE: Do not overtighten. Damage to the couplings may

result.

8. Turn the water faucet on.

9. Check for leaks around the ‘’Y’’ connector, faucet and

hose couplings.

SERVICING

WARNING - LABEL ALL WIRES

PRIOR TO DISCONNECTING WHEN

SERVICING CONTROLS. WIRING

ERRORS CAN CAUSE IMPROPER AND

DANGEROUS OPERATION AFTER

SERVICING/INSTALLATION.

For servicing phone numbers for replacement parts, and

other information, refer to Owner’s Manual or visit our

Web site.

5(*,67(5<2851(:$33/,$1&(725(&(,9($1<

,03257$17352'8&7127,),&$7,216

Please go to www.GEAppliances.com or mail in your

3URGXFW5HJLVWUDWLRQ&DUG

For questions on installation, call: 800.626.2000 (US) or

&DQDGD

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Hotpoint HTDP120EDWW Manuel d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Sèche-linge électrique Hotpoint HTDP120EDWW