Hotpoint KHM325FF Mode d'emploi télécharger pdf (Page 2)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24

Installation

! Before operating your new appliance, please read these

operating instructions carefully. They contain important

information for safe use, installation and care of the

appliance.

! Please keep these operating instructions for future

reference. Pass them on to possible new owners of the

appliance.

Positioning and connection

Positioning

1. Place the appliance in a well-ventilated humidity-free

room.

2. Do not obstruct the rear fan grills. The compressor

and condenser give off heat and require good ventilation

to operate correctly and save energy.

3. Ensure the appliance is far away from any sources of

heat (direct sunlight, electric stove, etc.).

Electrical connections

After transportation of the appliance, carefully place it

vertically and wait at least 3 hours before connecting it

to the electricity mains. Before inserting the plug into the

electrical socket ensure the following:

• Theapplianceisearthedandtheplugiscompliant

with the law.

• Thesocketcanwithstandthemaximumpowerofthe

appliance, which is indicated on the data plate located

on the bottom left side of the fridge (e.g. 150 W).

• Thevoltagemustbeintherangebetweenthevalues

indicated on the data plate located on the bottom left

side (e.g. 220-240V).

• Thesocketiscompatiblewiththeplugofthe

appliance.

If the socket is incompatible with the plug, ask an

authorised technician to replace it (see Assistance).

Donotuseextensioncordsormultiplesockets.

! Once the appliance has been installed, the power

supply cable and the electrical socket must be easily

accessible.

! The cable must not be bent or compressed.

! The cable must be checked regularly and replaced by

authorised technicians only (see Assistance).

! The manufacturer declines any liability should these

safety measures not be observed.

Your appliance is supplied with a 13amp fused plug that

can be plugged into a 13amp socket for immediate use.

Before using the appliance please read the instructions

below.

WARNING:

THIS APPLIANCE MUST BE EARTHED.

Replacing fuse covers:

When replacing a faulty fuse, a 13amp ASTA approved

fuse to BS 1362 should always be used and the fuse

cover re-fitted.

If the fuse cover is lost, the plug must not be used until a

replacement is obtained.

Replacement fuse covers:

If a replacement fuse cover is fitted, it must be of the

correct colour as indicated by the coloured marking or the

colour that is embossed in words on the base of the plug.

Changing the plug:

Removing the plug

If your appliance has a non-rewireable moulded plug and

you should wish to remove it to add a longer cable or

to re-route the mains cable through partitions, units etc.

please ensure that either:

- The plug is replaced by a fused 13amp re-

wireable plug bearing the BSI mark of

approval.

- The mains cable is wired directly into a

13amp cable outlet, controlled by a

switch (in compliance with BS 5733)

which is accessible without moving the

appliance.

Disposing of the plug

Cut off and dispose of the supplied plug if it does not

fit your socket. The cable should be cut as close as

possible to the moulded plug.

Remove the fuse.

1 2 3 4 5 6 7 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

Hotpoint KHM325FF Mode d'emploi Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Réfrigérateurs-congélateurs Hotpoint KHM325FF