Hotpoint GX641RX Mode d'emploi télécharger pdf (Page 10)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Start-up and use

! The position of the corresponding gas burner or electric

hotplate* is shown on every knob.

Gas cooker hobs are equipped with discrete power

adjustment that allows for accurately adjusting the ame to 5

different power levels. Thanks to this system, gas hobs are

also capable of guaranteeing the same cooking results for

each recipe, as the optimal power level for the desired type

of cooking can be identied in an easier, more accurate way.

Gas burners

Each burner can be adjusted to one of the following settings

using the corresponding control knob:

● Off

Maximum

Minimum

To light one of the burners, hold a lit match or lighter near

the burner and, at the same time, press down and turn the

corresponding knob anti-clockwise to the maximum setting.

Since the burner is tted with a safety device, the knob

should be pressed for approximately 2-3 seconds to allow

the automatic device keeping the ame alight to heat up.

When using models with an ignition button, light the desired

burner pressing down the corresponding knob as far as possible

and turning it anticlockwise towards the maximum setting.

! If a ame is accidentally extinguished, turn off the control

knob and wait for at least 1 minute before trying to relight it.

To switch off the burner, turn the knob in a clockwise

direction until it stops (when reaches the “●” position).

Discrete ame adjustment

The selected burner can be adjusted - by means of the knob

- to 5 different power levels. To shift between levels, simply

turn the knob towards the desired power level.

A click signals the passage from one power level to the other.

The selected power level is

indicated by the corresponding

symbol (symbols ) and,

on hobs equipped with a display,

by the LEDs that turn on (5 =

max. power; 1 = min. power). The

system guarantees accurate ame

adjustment and uniform cooking

results by facilitating selection of the desired power level.

The “double-ame” burner

This gas burner consists of two concentric ame rings that can

operate jointly or independently (in case of dual-control only).

As the burner is tted with a safety device, the knob

should be pressed down for approximately 2-3 seconds until

the device keeping the ame automatically alight heats up.

Dual control:

Each ring comprising the burner has its own control knob:

The knob marked with the symbol controls the outer ring.

The knob marked with the symbol controls the inner ring.

To activate any one of the two rings, press the corresponding

knob and turn it anti-clockwise to the maximum power

setting .

In order to use the double-flame burner to its full

potential, avoid simultaneously setting the inner ring to

minimum power and the outer ring to maximum power.

Single control:

The rings comprising the burner are activated through a

single control knob.

To simultaneously turn on both rings, position the knob on

the symbol (max) - (min) then press and turn the

knob anti-clockwise.

To turn on the inner ring only, position the knob on the symbol

(max ) - (min) then press and turn the knob clockwise.

(to switch modes, it is necessary to switch off the burner).

To switch off the burner, press and turn the knob clockwise

until it stops (when it reaches the “●” position).

Practical advice on using the burners

To ensure the burners operate efciently:

• Use appropriate cookware for each burner (see table)

so that the ames do not extend beyond the bottom of

the cookware.

• Always use cookware with a at base and a cover.

• When the contents of the pan reach boiling point, turn

the knob to minimum.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint GX641RX Mode d'emploi Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Hotpoint GX641RX