52
DECLARATION OF CONFORMITY
This cooktop is suitable for contact with
foodstuffs, and complies with EEC Directive 89/
109.
These appliances are designed solely for use as
cooking appliances.
Any other use (such as heating rooms) is to be
considered improper and, as a consequence,
dangerous.
The appliances are designed, built and sold in
compliance with:
- safety requirements of EEC Directive Low
voltage 73/23;
- protection requirements of EEC ECM Directive
89/336;
- requirements of EEC Directive 93/68.
ELECTRICAL CONNECTION
To be done before connection to the electricity supply.
The appliance must be installed by a qualified technician who
is fully aware of current safety and installation regulations and
who will comply with these regulations.
Make sure that the voltage indicated on the rating plate
corresponds to the voltage in your home.
Regulations require that the appliance is earthed; for this
reason all conductors and earth conductor must be of the
appropriate size.
Make sure the earth connection is made correctly. The
manufacturer declines all liability for injury to persons and
animals or damage to property resulting from failure to observe
the above regulations.
For the electrical connection use the HO5RR-F type cable
supplied as indicated in the table below:
An all-pole disconnect switch with minimum contact gap
equal to or greater than 3 mm must be used to install the hob.
Attention: the power supply cable must be long enough to
allow the hob to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Terminal block connections
Note: The earth wire (yellow/green) must be connected to the
terminal with the symbol and must be longer than the other wires.
-Connect the wires to the terminal block as indicated in the
diagram printed on the bottom of the hob.
-Secure the power supply cable (B) by means of the cable
clamp. Close the box lid (A).
After the initial electrical connection or whenever turning the
hob on/off, a symbol, (for example E-00,
E-01, E-02) will be displayed for a few seconds.
Power supply
voltage
Conductors
(number and size)
230 V
3 X 2.5 mm
2
min
3gb66055.fm Page 52 Friday, February 6, 2004 11:51 AM
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels