Hotpoint E600 Manuel d'utilisateur télécharger pdf (Page 12)

Electrical Connection - Model E6002

Electrical Connection

THIS APPLIANCE MUST BE EARTHED.

The installation procedure must be carried out by a qualified

electrician.

The electrical safety of this appliance is guaranteed only

if the appliance is correctly earthed in compliance with the

standards of electrical safety.

The manufacturer can under no circumstances be

considered responsible for any damage that might occur

due to incorrect earthing of the hob.

IMPORTANT POINTS:

Your hob is supplied with a special connection cable.

If ever the cable is damaged it should be replaced by an

authorised service engineer only.

Disconnect the hob form the electrical supply before any

work is carried out.

Voltage and frequency of power supply:

230-240V

50-60Hz

6500W

Electrical Connections:

To connect the supply cord, proceed as follows:

- Loosen the screws on the wire clamp "V", as well as the

screws for the contacts.

- Insert the wires beneath the contact screws, as shown in

the diagram and tighten them.

- Fasten the cord with the appropriate wire clamp and close

the cover.

* Application of the simultaneity coefficient in compliance

with standard EN 335-2-6

Y-type connection in compliance with standard

EN 335-2-6

Connecting the supply cord to the electrical mains:

The hob must be connected to a double pole mains switch

which must be installed between the appliance and the

mains.. The double pole mains switch must have a minimum

of 3mm of space between the contacts, be sized to the

load and comply with current regulations (the switch must

not be able to disconnect the earth conductor).

The supply cord should conform to BS6004 conductor size

4mm

and must be positioned so that no part of it reaches

a temperature of 50°C higher than room temperature.

Before making the connection, make sure that:

• the limiter switch and the residual wiring can support

the appliance load (see the rating plate).

• the mains system is properly earthed in compliance

with current regulations and provisions.

• there is easy access to the socket or the double pole

mains switch after the appliance is installed.

IMPORTANT:

If the hob is installed above a built-in oven, the electrical

connection for the hob must be independent of that for the

oven, both for safety reasons and to facilitate the removal

of the oven for maintenance, repair etc.

Fuse 20 A*

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Hotpoint E600 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Hotpoint E600