8
555
mm
475
mm
55
mm
Fastening Clamps - Assembly Diagram
Clamp Position for Clamp Position for
H=20mm top H=30mm top
Front
Clamp Position for
H=40mm top Back
N.B: Use the clamps contained in the "accessory kit."
f) In the event the cooktop is not installed above a built-in
oven, a wood panel must be inserted as insulation. This
panel must be placed at least 20 mm from the bottom of
the cooktop itself.
Important: When installing the cooktop above a built-in oven,
the oven should be placed on two wooden strips; in the case
of a joining cabinet surface, remember to leave a space of at
least 45 x 560 mm at the back.
560 mm.
45 mm.
When installing the cooktop above a built-in oven without
forced ventilation, ensure that there are air inlets and outlets
for ventilating the interior of the cabinet adequately.
Gas Connection for Cooktop
The cooktop should be connected to the gas supply by an
authorized installer. During installation of this product it is
essential to fit an approved gas tap to isolate the supply from
the appliance for the convenience of any subsequent removal
or servicing. Connection of the appliance to the gas mains or
liquid gas tanks must be carried out according to the safety
standards currently in force, and only after it is ascertained
that it is suitable for the type of gas to be used. If not, follow
the instructions indicated in the section entitled, “Adapting
the Cooktop for Different Types of Gas”. If the cooktop is to
be connected to tanks containing liquid gas, use pressure
regulators that comply with current safety standards.
Important: To insure that the appliance operates safety, the
gas is regulated correctly and your appliance lasts over time,
make sure that gas pressure levels comply with the indications
given in Table 1, “Nozzle and Burner Specifications”.
Gas Connection to Non-flexible Pipe
(copper or steel)
Connection to the gas source must be done in such a way as
to not create any stress points at any part of the appliance.
The appliance is fitted with an adjustable, "L" shaped connector
and a gasket for the attachment to the gas supply. Should
this connector have to be turned, the gasket must be replaced
(supplied with the appliance). The gas feed connector to the
appliance is a threaded, male 1/2" connector for round gas
pipe.
Gas Connection to Flexible Steel Pipe
The gas feed connector to the appliance is a threaded, male
1/2" connector for round gas pipe. Only use pipes, tubes and
gaskets that comply with current safety codes. The
maximum length of the flexible pipes must not exceed 2000
mm. Once the connection has been made, ensure that the
flexible metal tube does not touch any moving parts and is
not crushed.
Check the Seal
Once the appliance has been installed, make sure all the
connections are properly sealed, using a soapy water solution.
Never use a flame.
Electrical connection
Power supply voltage and frequency: 230-240V a.c. 50 Hz.
Note: the supply cable must be positioned so that it never reaches
at any point a temperature 50°C higher than the room temperature.
The cable must be routed away from the rear vents. Should you
require it, you may use a longer cable, however, you must ensure
that the cable supplied with the appliance is replaced by one of the
same specifications in accordance with current standards and
legislation.
(14 pages)
(28 pages)
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels