Hotpoint GPL 64L CI RFH Mode d'emploi télécharger pdf (Page 8)

Replacing the nozzles on separate “double ame “ burners

1. Remove the grids and slide the burners from their housings. The burner

consists of 2 separate parts (see gure);

2. Unscrew the burers with a 7 mm wrench spanner. The internal burner

has a nozzle, the external burner has two (of the same size). Replace

the nozzle with models suited to the new type of gas (see table 1).

3. Replace all the components by repeating the steps in reverse order.

• Adjusting the burners’ primary air

Does not require adjusting.

• Setting the burners to minimum

1. Turn the tap to the low ame position;

2. Remove the knob and adjust the adjustment screw, which is positioned

in or next to the tap pin, until the ame is small but steady.

! In the event of single-control DRDA (DCDR) burners, adjustment can be

performed by intervening on the 2 screws located near the tap pin (see picture).

Inner DRDA (DCDR)

burner adjustment

Total DRDA

(DCDR) burner

adjustment

3. Having adjusted the ame to the required low setting, while the burner is

alight, quickly change the position of the knob from minimum to maximum

and vice versa several times, checking that the ame does not go out.

4. Some appliances have a safety device (thermocouple) tted. If the device

fails to work when the burners are set to the low ame setting, increase

this low ame setting using the adjusting screw.

5. Once the adjustment has been made, replace the seals on the by-passes

using sealing wax or a similar substance.

6. In the event of discrete-adjustment knobs with LED visualisation, turn the

knob to the minimum power setting them remove it and intervene on the

adjustment screw located near the tap pin.

7. Minimum setting adjustment of the DRDA (DCDR) burner with discrete

adjustment and LED visualisation:

• To adjust the outer ring, turn the knob anti-clockwise to the minimum

power position.

• To adjust the minimum power setting of the inner ring, turn the knob

clockwise to the minimum power position.

• Remove the knob and intervene on the adjustment screw located near

the tap pin.

! If the appliance is connected to liquid gas, the regulation screw must be

fastened as tightly as possible.

! Once this procedure is nished, replace the old rating sticker with one

indicating the new type of gas used. Stickers are available from any of our

Service Centres.

! Should the gas pressure used be different (or vary slightly) from the

recommended pressure, a suitable pressure regulator must be tted to the

inlet pipe (in order to comply with current national regulations).

Electrical

connections

DATA PLATE

see data plate

This appliance conforms to the following

European Economic Community directives:

- 2006/95/EC dated 12/12/06 (Low Voltage)

and subsequent amendments

- 2004/108/EC dated 15/12/04

(Electromagnetic Compatibility) and

subsequent amendments

- 93/68/EEC dated 22/07/93 and subsequent

amendments.

- 2009/142/EC dated 30/11/06 (Gas) and

subsequent amendments

- 2012/19/EU and subsequent amendments.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Hotpoint GPL 64L CI RFH Mode d'emploi Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Hotpoint GPL 64L CI RFH