Hotpoint KIS 630 LD F Mode d'emploi télécharger pdf (Page 6)

EN 6

DECLARATION OF CONFORMITY

BEFORE USE

IMPORTANT: The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol “INDUCTION

SYSTEM” (Figure opposite). Place the pot on the required cooking zone before switching the hob on.

Using suitable pots, the cooking zones cannot be used at temperatures below 10°C.

EXISTING POTS AND PANS

NOOK

Use a magnet to check if the bottom of the pot is suitable for the induction hob: bottom of the pots and pans

are unsuitable if not magnetically detectable.

• Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.

• Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage.

RECOMMENDED POT BOTTOM WIDTHS

Place the pot on the required cooking zone before switching the hob on.

For good cooking results, the diameter of the base of the pot should match the size of the hotplate.

Diameter (cm) Max (cm) Min (cm) Diameter (cm) Max (cm) Min (cm)

14,5 14,5 10 28 28 17

18 18 12 30 30 17

21 21 15 FLEXI/CONNEXION 39 - 18 12

24 24 15

26 26 17

Pan size

To determine the size of the pot please measure the base of the pot (see picture) and refer to recommended pots bottom

width table, reported below, for perfect usage and correct pan detection. Each cooking zone has a minimum limit of detecting

pans, which varies depending on the material of the pan being used. You should therefore use the cooking zone that is most

suitable for the diameter of your pan.

RECOMMENDED POT POSITION

For best performance, when you use two pots simultaneously, put them according to the pictures below:

ECODESIGN Directive 2009/125/EC.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Hotpoint KIS 630 LD F Mode d'emploi Page 6