Hotpoint DSD60S S.0 Mode d'emploi télécharger pdf (Page 18)

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Care and Cleaning

Door and Control Panel (Glass)

Regularly wipe with a clean, damp cloth and polish

with a clean, dry cloth.

Door and Control Panel Trims (Stainless Steel)

Regularly wipe with a clean, damp cloth and polish

with a clean, dry cloth.

WARNING: TO AVOID ELECTRIC SHOCK,

BEFORE REPLACING THE OVEN LIGHT,

SWITCH THE COOKER OFF AT THE COOKER

CONTROL UNIT (and allow to cool if the oven

has been used).

Replacement of the Oven Light

Unscrew the glass cover, using a suitable cloth to

protect the fingers and remove carefully. Unscrew

the existing light bulb, and remove. Screw the new

bulb into position and replace the glass cover, with

metal washer, until positioned securely.

WARNING: BEFORE CLEANING, SWITCH THE

COOKER OFF AT THE MAINS COOKER CONTROL

PANEL AND ALLOW IT TO COOL. IT IS

ESSENTIAL THAT THE OVENS ARE CLEANED

AND KEPT FREE FROM FATS, OIL AND GREASE.

'Stay Clean' Liners*

'Stay Clean' liners are covered with a special enamel

which absorbs cooking soils. At higher temperatures

the soiling is slowly destroyed. In most cases normal

cooking at higher temperatures will permit this cleaning

to take place automatically. However, if higher cooking

temperatures are not used regularly then it may be

necessary, in order to prevent heavy soiling, to run the

oven at maximum temperature for at least two hours,

from time to time. The 'Stay Clean' liners can be

washed in warm soapy water followed by rinsing in

clear water. Dry well with a soft cloth.

NOTE: Do not use enzyme washing powder, harsh

abrasives or chemical oven cleaners of any kind.

Oven Fittings

The oven shelves can be cleaned either in a

dishwasher or by using a fine steel wool soap pad.

The grill and meat pans can be cleaned in warm

soapy water using a fine steel wool soap pad to

remove stubborn stains or in a dishwasher.

They should be cleaned after each use.

Oven Interiors

To clean the oven interiors remove all the oven

fittings and where applicable the 'Stay Clean' liners.

All types of oven cleaners can be used, but

do notdo not

do not

allow abrasive cleaners or oven spray to come into

contact with the 'Stay Clean' liners. Use a fine steel

wool soap pad to remove stubborn stains.

Oven Door Cleaning

The inner door glass panel can be removed for

easy cleaning, see “Care and Cleaning”.

Cooker Exterior

The outside of the cooker should be cleaned regularly

to keep it looking like new. Wipe over with a soft cloth

wrung out in warm water and dry with a soft clean

cloth. You can use mild non abrasive cleaners but

always read the manufacturer's instructions first.

Always test their suitability on a small area of the

cooker not noticeable in normal use.

NOTE: DO NOT use scouring pads or abrasive

cleaners as they may scratch the surface.

Wear protective gloves when cleaning any part of

your cooker.

REPLACEMENT OF OVEN LIGHT

BULB

CAUTION: DISCONNECT THE APPLIANCE

FROM THE ELECTRICITY SUPPLY BEFORE

REPLACING THE LAMP TO AVOID THE

POSSIBILITY OF AN ELECTRIC SHOCK.

Light bulbs are not covered by the manufacturer's

guarantee.

A new 25W, 300°C rated SES bulb can be obtained

from your cooker supplier or any major electrical

retailer.

1. Remove the shelves from the oven.

2. Unscrew the lens using a thick cloth to protect your

fingers in the unlikely event of a lens fracture.

3. Unscrew bulb.

4. Fit new bulb and refit lens.

! Do not use the oven lamp as/ for ambient

lighting.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Hotpoint DSD60S S.0 Mode d'emploi Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Micro-ondes Hotpoint DSD60S S.0